OPERATING FAULT
Before operating the spoiler, ensure that no one is in the proximity
of the moving parts to avoid any risk of injury.
If the control system fails, the indicator lamp in the control button
flashes, accompanied by an audible signal and a message in the
screen. As a safety precaution, the spoiler rises to the maximum
position, regardless of the speed of the vehicle.
Nevertheless, in the event of pinching, you must reverse the
movement of the spoiler. To do this, release the control button
then press it again to raise the spoiler.
If the problem persists and you wish to retract the spoiler:
F
F
F
stop where it is safe to do so,
switch off the ignition,
To exit from manual mode:
switch the ignition on again.
F
press the button briefly: the indicator lamp on the button goes off
(return to automatic mode).
If the indicator lamp no longer flashes, the failure was temporary, the
system has resumed normal operation. To retract the spoiler, refer to
the paragraph "To exit from manual mode".
At speeds below 6 mph (10 km/h), the spoiler stays in the open
position. It retracts automatically as soon as the vehicle exceeds
this speed threshold.
If the indicator lamp flashes again and the spoiler is still raised, the
system is still faulty.
Have it checked by a PEUGEOT dealer or a qualified workshop.
In the event of a system operating fault (e.g. jamming of the spoiler), the
indicator lamp in the control button flashes, accompanied by an audible
signal and a message in the screen. For safety reasons, do not exceed
a speed of 85 mph (140 km/h).
MAINTENANCE
To maintain the spoiler, with the vehicle stationary, ignition on:
F
F
raise the spoiler to the maximum position B by pressing the button
briefly,
Have it checked by a PEUGEOT dealer or a qualified workshop.
once the cleaning is complete, retract the spoiler: press and hold
the button until the end of the manoeuvre.
Never press on the spoiler to close the boot or push the vehicle as
this may damage it.
The keep this system in good working order, check the spoiler and its
housing periodically preventing the unwanted accumulation of leaves,
ice or snow.
The installation of load-carrying accessories on the vehicle limits
the effectiveness of the spoiler.
Before washing the vehicle, always retract the spoiler into its
housing.
Do not install load carrying accessories which are not
recommended by PEUGEOT.
Keep the end of the high-pressure nozzle at least 1 metre from the
spoiler housing.
94
English