Get Ease of use and comfort -> Interior fittings Guide for Peugeot Rifter 4 Door 2003-2017

Ease of use and comfort

Reꢀtting

Roof and its storage spaces

Interior ꢀttings

Mats

To refit the mat on the driver's side:

F position the mat correctly,

Overhead storage unit

Fitting

F reattach the fixings by pressing,

F check that the mat is secured correctly.

When fitting the mat for the first time, on the

driver's side, use only the fixings provided.

The other mats are simply placed on the

carpet.

To avoid any risk of jamming the pedals:

-

only use mats which are suited to the

fixings already present in the vehicle;

these fixings must be used.

3

-

never place one mat on top of another.

It is located above the sun visors and can be

used to store various objects.

The use of mats not approved by

PEUGEOT may interfere with access to

the pedals and hinder the operation of the

cruise control/speed limiter.

Central storage

The mats approved by PEUGEOT have

two fixings located below the seat.

A storage space is located in the roof lining.

The maximum authorised load is 6 kg.

Removing

In the event of sharp deceleration, objects

placed in the central storage compartment

of the roof may be transformed into

projectiles.

To remove the mat on the driver's side:

F move the seat as far back as possible,

F unclip the fixings,

F remove the mat.

63

Ease of use and comfort

Rear box

It can be accessed from the rear seats and

from the vehicle's boot.

Its capacity is 60 litres, and the maximum

authorised load is 10 kg.

Light ambience

12 V socket(s)

The light ambience can be

configured from the vehicle's

configuration menu.

(Depending on version.)

Blind

Opening/Closing

F To connect a 12 V accessory (maximum

power: 120 watts), lift the cover and plug in

the correct adapter.

F From the rear seats, slide the boot shutters

to open it.

F Press and hold the button; the blind opens/

closes and stops when you release the

button.

Do not exceed the maximum power rating

of the socket (otherwise there is a risk of

damaging your portable device).

If the blind meets an obstacle during

operation, you must reverse its movement.

To do this, press the switch concerned.

When pressing the button to open/close

the blind, the driver must ensure that

nothing and no one might interfere with its

movement.

The connection of an electrical device

not approved by PEUGEOT, such as

a USB charger, may adversely affect the

operation of vehicle electrical systems,

causing faults such as poor radio

reception or interference with displays in

the screens.

F From the vehicle's boot, place your thumb

on the boot recess then pull the handle to

open it.

The driver must ensure that passengers

use the blind correctly.

Be particularly aware of children when

operating the blind.

Open the rear box carefully to prevent any

objects stored inside from falling out.

64

Ease of use and comfort

F Remove the cover.

F Check that the indicator lamp is on and

green.

F Connect your multimedia or other electrical

device (telephone charger, laptop computer,

CD-DVD player, bottle warmer, etc.).

USB socket(s)

(Depending on version.)

When the USB socket is used, the

portable device charges automatically.

A message is displayed if the power drawn

by the portable device exceeds the current

supplied by the vehicle.

For more information on how to use this

equipment, refer to the Audio equipment

and telematics section.

In the event of a fault with the socket, the green

warning lamp flashes.

3

Have it checked by a PEUGEOT dealer or

a qualified workshop.

The sockets 1 and 2 also allow

a smartphone to be connected

by MirrorLink^TM, Android Auto^®or

CarPlay^®, so that certain smartphone

applications can be used on the

touch screen.

Connect only one device at a time to the

socket (no extension lead or multi-socket

connector).

Connect only devices with class II

insulation (shown on the device).

Do not use a device with a metal case

(electric shaver, etc.).

220 V/50 Hz socket

As a safety measure, when electrical

consumption is high and when required by

the vehicle's electrical system (particular

weather conditions, electrical overload,

etc.), the current supply to the socket will

be cut off; the green indicator lamp goes

off.

Sockets 1, 2 and 3 allow the connection of

a portable device, such as an iPod^®-type digital

audio player, to recharge the device.

Sockets 1 and 2 also allow the audio files to

be read, which are transmitted to your audio

system and played via the vehicle's speakers.

You can manage these files using the steering

mounted or touch screen controls.

AC 220V

50Hz

120W

A 220 V/50 Hz socket (max. power: 120 W)

is installed on the side of the central storage

compartment.

This socket works with the engine running, as

well as in STOP mode with Stop & Start.

65

Ease of use and comfort

Charging

Checking operation

Wireless smartphone

charger

F First ensure that the charging zone is clear

of other articles.

The state of the charge indicator lamp allows

the operation of the charger to be monitored.

F Place a portable device in the middle of the

charging zone.

Charge

Meaning

indicator lamp

Off

Engine switched off.

No compatible portable

device detected.

F Once the portable device is detected, the

charge indicator lamp comes on in green.

F Charging of the portable device's battery

then starts.

It allows the wireless charging of a portable

device, such as a smartphone, using the

principle of magnetic induction, based on the Qi

1.1 standard.

The portable device to be charged must be

compatible with the Qi standard, either by

design or by using a compatible holder or shell.

The charging zone is identified by the Qi

symbol.

Charging finished.

F Once the portable device's battery is fully

charged, the charge indicator lamp goes off.

Fixed, green

Compatible portable

device detected.

Charging…

The system only supports charging one

portable device at a time.

Flashing, orange Foreign object detected

in the charging zone.

Portable device not well

centred in the charging

zone.

Operation

The charger works with the engine running and

in STOP mode of Stop & Start.

Charging is managed by the smartphone.

Fixed, orange

Fault with the portable

device's battery meter.

Temperature of the

portable device's battery

too high.

For versions with Keyless Entry and Starting,

operation of the charger may be interrupted

when opening a door or switching off the

ignition.

Do not leave any metal objects (coins,

keys, vehicle remote control, etc.) in

the charging area while a device is

being charged – Risk of overheating or

interrupting the charging process!

Charger fault.

66

Ease of use and comfort

Aircraft style tables

Side blinds

They are fitted to the windows of the sliding

side doors (depending on version).

If the indicator lamp is lit orange:

-

remove the portable device, then place it

back in the middle of the charging zone.

or

-

remove the portable device and try again in

a quarter of an hour.

If the problem persists, have the system

checked by a PEUGEOT dealer or a qualified

workshop.

3

Floor boxes

F To put the table in place, pull it upwards.

As a safety precaution, the aircraft style table

unhooks itself if excessive pressure is applied.

F To put the table back in place, pull it

downwards.

F To raise or lower the blind, pull it by the tab.

To avoid damaging the blind:

Do not place hard or heavy objects on the

table. In the event of sharp deceleration,

these objects could become projectiles.

-

Guide it slowly using the tab, both up

and down.

-

Make sure the tab is properly secured

before opening the door.

There are two storage boxes located beneath

the rear passenger footwells.

F To open them, slide your fingers into the

notch and lift the cover.

67

Ease of use and comfort

F Fold down the rear seats.

F Tighten the straps without raising the bench

seat.

Installation behind row 1

High load retaining net

F Check that the net is attached securely and

properly extended.

Installation behind row 2

F Open the covers of the upper fixings 1.

F Unroll the high load retaining net.

F Position one of the ends of the net's metal

bar in the corresponding upper fixing 1, then

do the same with the other end.

Hooked onto the upper fixings and the lower

rings or lugs, this allows the use of the entire

loading volume up to the roof:

-

Behind the rear seats (row 2).

Behind the front seats (row 1) when the rear

seats are folded.

F Fully extend the straps.

F Fold or remove the luggage cover.

F Open the covers of the upper fixings 2.

F Unroll the high load retaining net.

F Position one of the ends of the net's metal

bar in the corresponding upper fixing 2, then

do the same with the other end.

F Attach the hook of each of the net's straps

in the corresponding stowing ring 4 (located

on the floor).

When positioning the net, check that the

strap loops are visible from the boot; this

will make slackening or tightening them

easier.

F Tighten the straps.

F Check that the net is attached securely and

properly extended.

F

Wind each strap around bar 3 located under

the front seat cushion (row 1), then secure each

spring hook to the corresponding strap ring.

68

Download User Manual App

Ease of use and comfort -> Interior fittings for Your Peugeot Rifter 4 Door 2003-2017

Related Topics

Ease of use and comfort

Popular Owner Manuals

Latest Owner Manuals