Ease of use and comfort
Refitting the seat
F Pull on the strap 3 to open the seat
anchorages.
F While still holding the strap 3, place the
anchorages in the anchorage points on the
floor.
F Lift the bar 2, located behind the seat,
to release the feet of the seat from their
anchorage in the floor.
F Tilt the entire seat forwards.
F Hook the strap 3 on the row 2 head restraint
rod.
F To remove it, press the lug A and pull it
upwards.
F To put it back in place, engage the head
restraint rods in the openings keeping them
in line with the seat backrest.
F To lower it, press the lug A and push down
on the head restraint at the same time.
F Release the strap 3.
Repositioning the seat
F Ensure that no object or feet are obstructing
the rear anchorage points 4 and that the seat
belt is correctly positioned and available.
F Fold the seat backwards to fix its rear
anchorage feet.
F Use the control 1 to lift the backrest into the
initial position.
F Refit the head restraint.
F Fold the entire seat backwards.
F Check that the seat belt is not trapped
during the manoeuvre.
The head restraint has a frame with
notches which prevents it from lowering;
this is a safety device in case of impact.
The adjustment is correct when the
upper edge of the head restraint is
level with the top of the head.
Never drive with the head restraints
removed; they must be fitted and correctly
adjusted.
Removing the seat
F Lower the head restraint as far as it will go.
F Place the seat in the fully folded position.
Adjusting the height of the
head restraint
Never drive with passengers seated at
the rear when the head restraints are
removed or not in the high position; the
head restraints must be in place and in the
high position.
For more information on the Seat belts,
refer to the corresponding section.
F Pull on the strap 3 to open the seat
anchorages.
F Still holding the strap 3, lift the seat.
F To raise it, pull it upwards as far as possible
(notch).
62
English 
