Advertisement

Advertisement

Download User Manual App

Quickly access user manual for free!

In the event of a breakdown -> Tool kit for Your Peugeot Rifter 4 Door 2003-2017

In the event of a breakdown  
F
Operate the priming pump  
repeatedly until resistance is felt  
(there may be resistance on the  
first press).  
With spare wheel  
Running out of fuel  
(Diesel)  
On vehicles fitted with Diesel engines, the fuel  
system must be primed if you run out of fuel.  
If the engine does not start first time, do not  
keep trying, but start the procedure again from  
the beginning.  
F Operate the starter to start the engine (if the  
engine does not start at the first attempt,  
wait around 15 seconds before trying  
again).  
F If the engine does not start after a few  
attempts, operate the priming pump again  
then start the engine.  
F Put the cover back in place and clip it in.  
F Close the bonnet again.  
The jack is located under the right-hand front  
seat.  
The tools are located under the left-hand front  
seat.  
For more information on Misfuel  
prevention (Diesel), refer to the  
corresponding section.  
Details of the tool kit  
BlueHDi engines  
Tool kit  
F Fill the fuel tank with at least five litres of  
Diesel fuel.  
F Switch on the ignition (without starting the  
engine).  
F For easier access, move the seat(s)  
forward.  
Access to the tools  
F Wait around 6 seconds and switch off the  
ignition.  
With temporary puncture repair  
kit  
F Repeat the operation 10 times.  
F Operate the starter to run the engine.  
1. Chock to immobilise the vehicle.  
2. Removable towing eye.  
3. Torx key.  
Other engines  
8
Permits removal of the rear lamps in order  
to change a bulb.  
F Fill the fuel tank with at least five litres of  
Diesel fuel.  
F Open the bonnet.  
F If necessary, unclip the cover to access the  
priming pump.  
The kit is located under the right-hand front  
seat.  
195  
In the event of a breakdown  
With temporary puncture repair  
kit  
With a spare wheel  
All of these tools are specific to your  
vehicle and may vary depending on  
equipment.  
Do not use them for any other purposes.  
The jack must only be used to change a wheel  
with a damaged or punctured tyre.  
The jack does not require any maintenance.  
The jack meets European standards, as defined  
in the Machinery Directive 2006/42/CE.  
6. Wheelbrace.  
4. Temporary puncture repair kit.  
Contains a 12 V compressor and  
Certain parts of the jack such as the screw  
thread or the joints could cause injury:  
avoid touching them.  
Carefully remove all traces of lubrication  
grease.  
For removing the wheel bolts and raising/  
lowering the jack.  
a cartridge of sealant to temporarily repair  
the wheel and adjust the tyre pressure.  
7. Jack.  
Used to raise the vehicle.  
5. Speed limit sticker.  
8. Wheel bolt cover/wheel trim removal tools  
(depending on equipment).  
If present on your vehicle, it removes the  
wheel bolt covers on alloy wheels or the  
wheel trim on steel wheels.  
For more information on the Temporary  
puncture repair kit, refer to the  
corresponding section.  
Temporary puncture  
repair kit  
9. Socket for the wheel security bolts.  
Used for adapting the wheelbrace to the  
special "security" bolts.  
Scan the QR code on page 3 to view  
explanatory videos.  
For more information on the Spare wheel,  
refer to the corresponding section.  
Comprising a compressor and a sealant  
cartridge, it allows the temporary repair of  
a tyre so that you can drive to the nearest  
garage.  
196