Driving -> Electric parking brake for Your Peugeot Rifter 4 Door First Generation (2018-2023)

Driving  
Remote control not  
recognised with Keyless  
Entry and Starting  
Manual parking brake  
Pressing the brake pedal facilitates the  
application and release of the manual  
parking brake.  
Application  
If the remote control is no longer in the  
recognition zone when you close a door or  
when you (later) request switching off of the  
engine, a message appears in the instrument  
panel.  
F If you want to force switching off of the  
engine, press and hold the "START/STOP"  
button for about 3 seconds, then contact  
a PEUGEOT dealer or a qualified workshop.  
F With your foot on the brake pedal, pull the  
parking brake lever up to immobilise your  
vehicle.  
With a manual gearbox, engage a gear  
then switch off the ignition.  
With an automatic gearbox, place the gear  
selector in position P then switch off the  
ignition.  
Release on level ground  
Electric parking brake  
The system provides, in automatic operation,  
for the application of the parking brake on  
switching off the engine and its release as the  
vehicle moves off.  
Anti-theft protection  
Electronic immobiliser  
The remote control contains an electronic chip  
which has a special code. When the ignition is  
switched on, this code must be recognised in  
order for starting to be possible.  
F With your foot on the brake pedal, pull the  
parking brake lever up gently, press the  
release button, then lower the lever fully.  
A few seconds after switching off the ignition,  
this system locks the engine control system,  
therefore preventing the engine from being  
started in the event of a break-in.  
When the vehicle is being driven, this  
warning lamp coming on, accompanied  
by an audible signal and a message,  
indicates that the parking brake is still  
applied or has not been fully released.  
In the event of a fault, you are  
informed by illumination of this  
warning lamp, an audible signal and  
a message in the screen.  
The driver can take over at any time to apply  
or release the parking brake, by operating the  
control lever:  
F by briefly pulling the control lever to apply  
the brake,  
When parking on a slope, or on a steep  
slope with a laden vehicle, turn the wheels  
against the kerb then apply the parking  
brake.  
The vehicle will not start; contact a PEUGEOT  
dealer as soon as possible.  
126