In the event of a breakdown
F
Operate the priming pump
repeatedly until resistance is felt
(there may be resistance on the
first press).
With spare wheel
Running out of fuel
(Diesel)
On vehicles fitted with Diesel engines, the fuel
system must be primed if you run out of fuel.
If the engine does not start first time, do not
keep trying, but start the procedure again from
the beginning.
F Operate the starter to start the engine (if the
engine does not start at the first attempt,
wait around 15 seconds before trying
again).
F If the engine does not start after a few
attempts, operate the priming pump again
then start the engine.
F Put the cover back in place and clip it in.
F Close the bonnet again.
The jack is located under the right-hand front
seat.
The tools are located under the left-hand front
seat.
For more information on Misfuel
prevention (Diesel), refer to the
corresponding section.
Details of the tool kit
BlueHDi engines
Tool kit
F Fill the fuel tank with at least five litres of
Diesel fuel.
F Switch on the ignition (without starting the
engine).
F For easier access, move the seat(s)
forward.
Access to the tools
F Wait around 6 seconds and switch off the
ignition.
With temporary puncture repair
kit
F Repeat the operation 10 times.
F Operate the starter to run the engine.
1. Chock to immobilise the vehicle.
2. Removable towing eye.
3. Torx key.
Other engines
8
Permits removal of the rear lamps in order
to change a bulb.
F Fill the fuel tank with at least five litres of
Diesel fuel.
F Open the bonnet.
F If necessary, unclip the cover to access the
priming pump.
The kit is located under the right-hand front
seat.
195
English