2016-2026 Peugeot Traveller Van Driving -> Collision Risk Alert / Active Safety Brake User Manual
MyCarUserManual.com
USER MANUALS FOR EVERY MAKE & MODEL

Driving -> Collision Risk Alert / Active Safety Brake for Your Peugeot Traveller Van First Generation (2016-2026)

Driving  
Conditions for  
Collision Risk Alert and Active Safety  
Brake  
operation  
The Collision Risk Alert system only  
operates:  
-
with a registered vehicle pointing in the  
same direction as the traffic, moving or  
stationary,  
-
-
with pedestrians.  
from 4 mph (7 km/h) (and is deactivated at  
3 mph (5 km/h)).  
The Collision Risk Alert system allows the  
driver to be warned that their vehicle is at  
risk of collision with the vehicle in front or a  
pedestrian in their traffic lane.  
The Active Safety Brake system intervenes  
following the alert if the driver does not  
react quickly enough and does not operate  
the vehicle's brakes.  
If the driver fails to act, it contributes  
towards avoiding a collision or limiting  
its severity by reducing the speed of your  
The Active Safety Brake system operates:  
-
-
-
between 3 and 87 mph (5 and 140 km/h), in  
the case of a moving vehicle,  
at a speed below 50 mph (80 km/h), in the  
case of a stationary vehicle,  
at a speed below 36 mph (60 km/h), in the  
case of a pedestrian,  
These systems use a radar located in the  
front bumper and a camera at the top of the  
windscreen.  
6
-
-
-
if the passenger seat belts are fastened,  
if the vehicle is not accelerating sharply,  
if the vehicle is not in a tight corner.  
vehicle.  
These system are designed to improve  
road safety.  
It is the driver's responsibility to  
continuously monitor the state of the  
traffic, observing the driving regulations.  
These systems do not replace the need  
for vigilance on the part of the driver.  
239  
Driving  
The Active Safety Brake system does not  
operate:  
Limits of operation  
Collision Risk Alert  
It is recommended that the system be  
deactivated in the vehicle configuration menu  
in the following cases:  
-
-
if the front bumper is damaged,  
if the system has been triggered in the last  
10 seconds,  
if the electronic stability control system has  
a fault.  
Depending on the degree of risk of collision  
detected by the system and the alert threshold  
chosen, different levels of alert can be  
triggered and displayed in the instrument panel  
or the head-up display.  
-
if the windscreen has impact damage close  
to the detection camera,  
-
-
-
when towing a trailer or caravan,  
when a load on the roof rack extends  
beyond the windscreen (for example: long  
objects),  
This information also appears in the  
head-up display.  
Following an impact, the system  
is automatically disabled; contact  
a PeugeoT dealer or a qualified  
workshop to have the system checked.  
-
-
-
when the vehicle is being towed, with the  
engine running,  
when a "space-saver" type spare wheel is  
fitted (if your vehicle has one),  
when on a rolling road for a service in a  
workshop,  
For more information on the Head-up  
display, refer to the corresponding  
section.  
-
-
when in an automatic car wash,  
if the brake lamps are not working.  
Level 1 : visual alert only, warning  
you that the vehicle ahead is very  
close.  
A message on your vigilance is  
displayed as you close on the vehicle  
ahead.  
This level of alert is based on the inter-vehicle  
time between your vehicle and the vehicle  
ahead.  
240  
Driving  
Level 2: visual and audible alert,  
warning you that a collision is  
imminent.  
A message indicating that you should  
brake is displayed.  
Programming the alert  
thresholds  
The thresholds for triggering an alert determine  
how you wish to be warned of the presence of a  
vehicle moving or stationary ahead of you, or a  
pedestrian in your traffic lane.  
With the audio system  
In the "Personalisation-configuration"  
menu, activate/deactivate "Auto. emergency  
braking".  
You can select one of three thresholds:  
This level of alert is based on the time before  
collision. It takes account of the vehicle  
dynamics, the speed of your vehicle and the  
one in front, the environmental conditions, the  
operation of the vehicle (cornering, pedals  
pressed, etc.) to trigger the alert at the best  
moment.  
-
"Distant", to be warned early (cautious  
driving).  
Then modify the alert threshold.  
-
-
"Normal".  
"Close", to be warned later.  
With the touch screen  
Where the speed of your vehicle is too  
high approaching another vehicle, the  
first level of alert may not be displayed:  
the level 2 alert may be displayed  
directly.  
Furthermore, the level 1 alert is never  
displayed with the "Close" threshold.  
Poor weather conditions (very heavy  
rain, accumulation of snow in front of  
the radar and the camera) may hinder  
the operation of the system, with the  
display of an operating fault message.  
The system remains out of service until  
the message disappears.  
6
In the vehicle settings menu, activate/  
deactivate "Collision risk alert and automatic  
braking".  
Then modify the alert threshold.  
Press on "Confirm" to save the change.  
241  
Driving  
If the radar and the camera have  
confirmed the presence of a vehicle  
or a pedestrian, this warning lamp  
flashes when the system is operating.  
Active Safety Brake  
operation of the system may be felt by  
slight vibration in the brake pedal.  
If the vehicle comes to a complete stop,  
the automatic braking is maintained for  
1 to 2 seconds.  
If your vehicle has a manual gearbox, in  
the event of the automatic emergency  
braking bringing the vehicle to a  
Important: if operation of the  
automatic emergency braking is  
triggered, you should take back  
control of your vehicle and brake  
with the pedal to add to or finish the  
automatic braking.  
complete stop, the engine may stall.  
If your vehicle has an automatic  
gearbox, in the event of the automatic  
emergency braking bringing the vehicle  
to a complete stop, the vehicle will  
move off again; press the brake pedal.  
The driver can take back control of the vehicle  
at any time by sharply turning the steering  
wheel and/or pressing the accelerator pedal.  
If automatic emergency braking is  
not activated, you are alerted by the  
fixed display of this warning lamp  
accompanied by a message.  
This system, also called automatic emergency  
braking, aims to reduce the speed of impact  
or avoid a frontal collision by your vehicle  
(between 3 and 87 mph (5 and 140 km/h)  
where the driver fails to react.  
using a radar and a camera, this system acts  
on the vehicle's braking system.  
242  
Driving  
Deactivation / Activation of  
the alert and the braking  
Operating fault  
Intelligent emergency  
braking assistance  
By default, the function is automatically  
In the event of a fault, you are alerted  
by the illumination of this warning  
lamp, accompanied by an audible  
signal and a message.  
Contact a PeugeoT dealer or a  
qualified workshop.  
If the driver does not brake sufficiently  
to avoid an accident, this system will  
complete the braking.  
This emergency braking system will not  
act if you press the brake pedal.  
activated at every engine start.  
The deactivation or activation of the function is  
done in the vehicle configuration menu.  
There may be interference in the  
operation of the camera or it not work at  
all in the following situations:  
With the audio system  
-
poor visibility (inadequate street  
lighting, falling snow or rain, fog, ...),  
dazzle (headlamps of an  
-
approaching vehicle on the other  
side of the road, low sun, reflection  
on a wet road, leaving a tunnel,  
alternating between light and  
shade, ...),  
the area in front of the windscreen:  
dirty, misty, frosty, snow-covered,  
damaged or covered by a sticker.  
In the "Personalisation-configuration"  
menu, activate/deactivate "Auto. emergency  
braking".  
6
-
With the touch screen  
The operation of the radar, located in  
the front bumper, may be disturbed  
in certain weather conditions: with  
accumulations of snow, ice, mud, ...  
In the vehicle settings menu, activate/  
deactivate "Collision risk alert and automatic  
braking".  
243  
Driving  
If one of the two sensors (camera  
Keep the windscreen in front of the  
camera clean.  
Do not allow snow to accumulate on  
the bonnet or roof of the vehicle as this  
could mask the camera's view.  
or radar) is masked or its visibility  
is reduced, while the other sensor  
is able to work normally, the system  
still operates, but at a lower level of  
performance. This is not indicated by a  
message or a warning lamp.  
To ensure correct operation of the radar  
radar, do not paint over the paintwork  
on the vehicle's bumper.  
Clean the front bumper, removing the  
snow, mud, ...  
244  

Related Topics

Popular Owner Manuals