2016-2026 Peugeot Traveller Van Driving -> Starting / Switching off the engine User Manual
MyCarUserManual.com
USER MANUALS FOR EVERY MAKE & MODEL

Driving -> Starting / Switching off the engine for Your Peugeot Traveller Van First Generation (2016-2026)

Driving  
Starting-switching off the engine, manual key, remote control  
Ignition switch  
Starting using the key  
The parking brake must be applied.  
F
If your vehicle has an electronic gearbox,  
place the selector at position N then press  
the brake pedal firmly.  
1. Stop position.  
2. Ignition on position.  
3. Starting position.  
F
If your vehicle has a manual gearbox, place  
the gear lever in neutral then fully depress  
the clutch pedal.  
6
F
F
Insert the key in the ignition switch.  
The system recognises the starting code.  
unlock the steering column by  
simultaneously turning the steering wheel  
and the key.  
F
If your vehicle has an automatic gearbox,  
place the selector at position P then press  
the brake pedal firmly.  
In certain circumstances, you may  
have to turn the steering wheel firmly to  
move the road wheels (if the wheels are  
against a kerb, for example).  
195  
Driving  
The warning lamp does not come  
on if the engine is already warm.  
Depending on the climatic conditions,  
it is recommended that you proceed as  
follows:  
If the engine does not start straight  
away, switch off the ignition.  
Wait a few moments before trying  
again. If the engine does not start after  
a few attempts, do not keep trying: you  
risk damaging the starter motor and the  
engine.  
-
-
-
In temperate conditions, do not  
run the engine with the vehicle  
stationary to warm it up, but rather  
move off straight away and drive at  
moderate engine speeds.  
In wintry conditions, the pre-heater  
warning lamp will stay on for a  
longer period after switching on the  
ignition; wait until it goes off before  
starting.  
Call on a PeugeoT dealer or a  
qualified workshop.  
F
Turn the key to position 2, ignition on, to  
operate the engine pre-heating.  
In very severe wintry  
F
Wait until this warning lamp  
conditions (temperature  
goes off in the instrument panel  
then operate the starter motor  
by turning the key to position 3  
until the engine starts, without  
pressing the accelerator. once  
the engine starts, release the key.  
below -23°C), to ensure the correct  
operation and durability of the  
mechanical components of your  
vehicle (engine and gearbox), leave  
the engine running for 4 minutes  
before moving off.  
Never leave the engine running in  
an enclosed area without adequate  
ventilation: internal combustion  
engines emit toxic exhaust gases,  
such as carbon monoxide. Danger of  
intoxication and death.  
196  
Driving  
Switching off using the key  
To avoid any risk of jamming of the  
pedals:  
When leaving the vehicle, remove the  
key and lock the doors.  
As a safety measure (children on  
board), never leave the vehicle without  
your remote control with you, even for a  
short period.  
F
Immobilise the vehicle.  
-
only use mats which are suited to  
the fixings already present in the  
vehicle; these fixings must be used,  
never fit one mat on top of another.  
-
The use of mats not approved by  
PeugeoT may interfere with access to  
the pedals and hinder the operation of  
the cruise control / speed limiter.  
The mats approved by PeugeoT have  
two fixings located below the seat.  
Switching off the engine leads to a loss  
of braking assistance.  
F
Turn the key fully towards you to position 1  
(Stop).  
F
F
Remove the key from the ignition switch.  
To lock the steering column, turn the  
steering wheel until it locks.  
Avoid attaching heavy objects to the  
key, which would weigh down on its  
blade in the ignition switch and could  
cause a malfunction.  
6
To facilitate unlocking of the steering  
wheel, it is recommended that you  
place the wheels in the straight ahead  
position before switching off the engine.  
Key left in the "Ignition on"  
position  
If the key has been left in the ignition  
switch at position 2 (Ignition on),  
the ignition will be switched off  
automatically after one hour.  
F
Check that the parking brake is  
correctly applied, particularly  
when parking on a slope.  
To switch the ignition back on, turn the  
key to position 1 (Stop), then back to  
position 2 (Ignition on).  
Never switch off the ignition until the vehicle  
has been brought to a complete stop.  
197  
Driving  
Starting-switching off the engine,  
"Keyless entry and starting"  
Starting  
F
Then, press the "START/  
STOP" button.  
F
If your vehicle has an automatic gearbox,  
place the selector at position P then press  
the brake pedal firmly.  
The steering column unlocks and the engine  
starts more or less immediately.  
F
Place the remote control inside the vehicle,  
in the recognition zone.  
For Diesel vehicles, in sub-  
zero temperatures the engine  
will not start until the pre-heater  
warning lamp has gone off.  
If this warning lamp comes on  
after pressing the "START/SToP"  
button, press down on the brake  
or clutch pedal until the warning  
lamp goes off, without pressing  
the "START/SToP" button again,  
until the engine starts and runs.  
F
If your vehicle has an electronic gearbox,  
place the selector at position N then press  
the brake pedal firmly.  
F
If your vehicle has a manual gearbox, fully  
depress and hold down the clutch pedal  
until the engine starts.  
198  
Driving  
Switching off  
Ignition on  
(without starting)  
The presence in the recognition zone of  
the remote control of the "Keyless entry  
and Starting" system is essential.  
Never leave the vehicle with the engine  
running and with the remote control on  
your person.  
F
Immobilise the vehicle.  
With the remote control in the  
F
recognition zone, press the  
"START/STOP" button.  
If the remote control leaves the  
recognition zone, a message is  
displayed.  
Move the remote control into the zone  
to be able to start the engine.  
The engine stops and the steering column is  
locked.  
If the vehicle is not immobilised, the  
engine will not stop.  
With the Keyless entry and Starting  
remote control inside the vehicle,  
pressing the "START/SToP" button,  
with no action on the pedals, allows the  
ignition to be switched on.  
This also allows the accessories to be used  
(for example: audio system, lighting...).  
If one of the starting conditions is  
not met, a message appears in the  
instrument panel screen. In some  
circumstances, it is necessary to  
turn the steering wheel slightly while  
pressing the "START/SToP" button  
to assist unlocking of the steering;  
a message warns you when this is  
needed.  
To avoid any risk of jamming of the  
pedals:  
6
-
only use mats which are suited to  
the fixings already present in the  
vehicle; these fixings must be used,  
never fit one mat on top of another.  
F
F
Press the "START/SToP" button,  
the instrument panel comes on  
but the engine does not start.  
-
The use of mats not approved by  
Press the button again to switch  
off the ignition and allow the  
vehicle to be locked.  
PeugeoT may interfere with access to  
the pedals and hinder the operation of  
the cruise control / speed limiter.  
The mats approved by PeugeoT have  
two fixings located below the seat.  
With the ignition on, the system  
automatically goes into energy  
economy mode to maintain an adequate  
state of charge in the battery.  
199  
Driving  
F
F
Place and hold the remote control against  
the reader, then:  
Back-up starting  
Remote control not  
recognised  
Should your vehicle not detect the electronic  
key in the recognition zone, because the  
remote control battery is flat, a back-up reader  
is provided to the left, behind the steering  
wheel to allow starting.  
If your vehicle has a manual gearbox, place  
the gear lever in neutral then fully depress  
the clutch pedal.  
F
F
If your vehicle has an automatic gearbox,  
place the selector at position P then press  
the brake pedal firmly.  
If your vehicle has an electronic gearbox,  
place the selector at position N then press  
the brake pedal firmly.  
If the remote control is no longer in the  
recognition zone when you close a door or  
when you (later) request switching off the  
engine, a message appears in the instrument  
panel.  
F
Press the "START/SToP" button.  
The engine starts.  
Forced switch-off  
In the event of an emergency only and with the  
vehicle stationary, you can switch off the engine.  
F
If you want to force switching off the  
engine, press and hold the "START/SToP"  
button for about 3 seconds, then contact a  
PeugeoT dealer or a qualified workshop.  
To do this, press and hold the "START/SToP"  
button for about 3 seconds.  
In this case the steering column locks as soon  
as the vehicle stops.  
200  

Related Topics

Driving
Driving recommendations Parking brake Hill start assist Manual gearbox / Gear shift indicator Automatic gearbox Electronic gearbox Stop & Start Head-up display Speed limiters and Cruise Control Collision Risk Alert / Active Safety Brake Lane departure / Fatigue detection Blind spot monitoring system Parking sensors Reversing camera / 180? vision Under-inflation detection

Popular Owner Manuals

Audi
Audi
BMW
BMW
Citroen
Citroen
Ford
Ford
Honda
Honda
Peugeot
Peugeot