
A
B
C
D
E
F
G
H
I
J
K
L
M
N
O
P
Q
R
S
T
U
V
W
X
Y
Z
Lights
151
The indicator light lights up.
Switching off
e Push the stalk once to pressure point 4.
The indicator light
goes out.
Switching dynamic high beam on and off
bb Vehicles with Porsche Dynamic Light System
Plus (PDLS Plus).
bb Automatic headlights switched on.
bb Dynamic high beam activated.
Switching on
e Push the stalk once to pressure point 3.
The indicator light
lights up.
Vehicles with LED headlights: Changes are made
automatically in several stages between dipped-
beam and full high-beam illumination.
Vehicles with LED Matrix headlights: Depending
on various factors, such as the position of other
vehicles and speed, the individual LED segments
of the high beam headlights are activated or
deactivated.
If high beam are partly or fully activated, the in-
dicator light
comes on.
Switching off
e Push the stalk once to pressure point 4.
The dynamic high beam can only be deactivated
when the indicator light
is on.
If the dynamic high beam was deactivated or if the
requirements for the dynamic high beam are not
met, high beam can be switched on and off
manually.
Switching on manually
e Push the stalk twice to pressure point 3.
The indicator light
lights up.
Switching off manually
e Push the stalk once to pressure point 4.
The indicator light
goes out.
Operating the headlight flasher
e Briefly push the stalk once to pressure point 4.
The indicator light
comes on briefly.
Switching parking lights on and off
bb Operational readiness switched off.
e Press the stalk past pressure point 2 or 1 to
switch on the right or left parking light.
When the parking light is switched on, a mes-
sage appears on the instrument cluster after the
door is opened.
Switching hazard warning lights
on/off
Fig. 112: Switching hazard warning lights on and off
Switching hazard warning lights on and off
e Press the hazard warning light button on the
centre console.
All direction indicators and the button flash.
Deactivating hazard warning lights after
emergency braking
If the vehicle is travelling at a speed of more than
approx. 70 km/h (43 mph) and is braked fully to a
standstill, the hazard warning lights are activated
automatically. The brake lights flash during braking.
e Press the hazard warning light button on the
centre console to deactivate the hazard warning
lights. The hazard warning lights are deactivated
automatically when the vehicle begins to move
again.
Hazard warning lights following an accident
The hazard warning lights are activated automati-
cally in the event of an accident in which the airbag
is triggered.
Activating overseas mode
When you cross the border into a country where
traffic drives on the other side of the road, the light
distribution of the headlights must be adapted.
Adaptation of the light distribution normally occurs
automatically based on the navigation data.
After conversion, a message appears in the instru-
ment cluster every time the ignition is turned on and
the vehicle is ready for operation.
If conversion does not occur automatically, this can
also be performed manually on the central display:
e
e Setting e Vehicle settings e Light and
visibility e Exterior lights e Inverted setting of
dipped beam
e Readjust headlights on the return journey.
Changing bulbs
The vehicle's exterior and interior lights are fitted
with LEDs. The LEDs cannot be replaced individually.