2019-2024 Porsche Taycan 2 Door Lights -> Switching automatic headlights/exterior lights on and off User Manual
MyCarUserManual.com
USER MANUALS FOR EVERY MAKE & MODEL

Lights -> Switching automatic headlights/exterior lights on and off for Your Porsche Taycan 2 Door First Generation (2019-2024)

A
B
C
D
E
F
G
H
I
J
K
L
M
N
O
P
Q
R
S
T
U
V
W
X
Y
Z
Lights
148
What do I want to do? What do I have to do? Where?
Switch on rear flog light
e Press the
button. –
Switch exterior lights off completely
e Press the
button for approx. 2 seconds.
The green lighting of the
button goes out. All exterior lights remain switched off completely
until a speed of 10 km/h or a driven distance of 100 m has been exceeded.
> p. 148
General safety instructions
WARNING
Driving without lights
If you drive without lights, this may significantly re-
strict your visibility and also the ability of other road
users to see your vehicle.
e Carefully monitor the automatic headlights and
switch the dipped beam headlights on manually
if necessary.
e Observe the laws on driving with dipped beam
headlights in the specific country.
WARNING
Lack of attention when
driving with dynamic
high beam
In spite of dynamic high beam, it is always the driv-
er’s responsibility to manually adapt high beam ac-
cording to light conditions, visibility and traffic
conditions during driving, for example. The system is
not a substitute for careful attention on the part of
the driver. Manual intervention may be required in
the following situations:
– in unfavourable weather conditions, such as rain,
fog, snow, ice, heavy spray
– on roads where oncoming traffic is partly
obscured, e.g. motorways
– where there are road users with poor lighting, e.g.
cyclists
– on narrow bends, steep crests or hollows
– in poorly lit villages and towns
– where there are strong reflectors, e.g. signs.
– where the windscreen in the camera area is
misted, dirty, icy or covered with stickers.
e Drive with extreme care.
e Always pay attention to the traffic situation and
the area around the vehicle.
e If necessary, manually adjust the high beam to
the light, visibility and traffic conditions.
Responding to warning messages
Always heed any warning and information messages
displayed in the vehicle.
> Please refer to chapter "Warning and information
messages" on page 271.
Switching automatic headlights/
exterior lights on and off
Switching on automatic headlights
e Press the
button.
The button lights up green. The pilot light
lights up white.
The dipped beams are switched on automatically in
the following situations:
– Dusk
– Darkness
– Driving through tunnels
– Rain
When low beams are switched on automatically, the
button lights up green. The pilot light lights
up.
Information
Fog is not recognised.
e In the event of fog, switch on the dipped beams
and rear fog light manually.
Switch exterior lights off completely
e Press the
button for approx. 2 seconds.
The green light in the
button goes out.
The automatic lights are switched on again in the
following situations
1
:
– from a speed of 10 km/h (6 mph)
– when a distance of more than 100 m has been
driven after switching off the exterior lights
1. Country-dependent
A
B
C
D
E
F
G
H
I
J
K
L
M
N
O
P
Q
R
S
T
U
V
W
X
Y
Z
Lights
149
Information
The vehicle’s exterior lights can mist up depending
on temperature and humidity. This misting will
evaporate after a sufficient distance has been driven.
Adjusting Automatic Coming
Home lights
bb Automatic headlights switched on.
The following lights may be switched on for a certain
period to allow you to get in and out of your vehicle
with improved visibility in darkness:
When the last vehicle door is closed or after unlock-
ing the vehicle, the following lights are switched on:
– Daytime running lights
– Dipped beams when approaching
– Front and rear side marker lights
– Number plate light
These are switched off again when operational
readiness is switched on or the automatic headlights
are switched off.
The duration of the off delay can be set on the cen-
tral display.
e
e Setting eVehicle e Light and visibility
e Exterior lights e Fade-out duration
Porsche Dynamic Light System
Plus (PDLS Plus) with LED
headlights
bb Automatic headlights switched on.
Dynamic cornering lights
Above a speed of around 5 km/h (3 mph), the dip-
ped beam or high-beam headlights are swivelled in
the direction of the curve to illuminate the road more
clearly, depending on the speed of the vehicle and
the extent to which the steering wheel is turned.
Situational lighting distribution
Depending on the country, situational lighting con-
trol adapts the light distribution of the dipped and
high-beam headlights to urban, country-road or
motorway driving.
Adverse weather lights
When the fog lights are switched on, the dipped
beam distribution changes at a speed of less than
approx. 60 km/h (38 mph). The light beam becomes
wider and reduces glare.
Dynamic high beam
Fig. 109: Windscreen camera
Light sources of other road users can be detected by
camera A in the vicinity of the interior mirror. Their
detection continuously adjusts the light/dark limit of
the driving light in several phases between dipped-
beam and full-high beam illumination. The stage is
selected in such a way that the light/dark limit of the
driving light reaches the next recognised vehicle.
Dynamic high beam is switched on or off at speeds
between 30 km/h (20 mph) and
60 km/h (37 mph)), depending on the navigation
data. Full high-beam illumination is switched to dip-
ped beam when the camera detects street lights.
Dynamic high beam can be activated or deactivated
on the central display:
e
e Setting eVehicle e Light and visibility
e Exterior lights e Dynamic high beam
Information
To avoid impairing the detection performance:
e Do not cover the camera area on the interior
mirror with objects (e.g. stickers).
e The camera must always be kept free of dirt, ice
and snow.
Porsche Dynamic Light System
Plus (PDLS Plus) with LED-Matrix
headlights
bb Automatic headlights switched on.
PDLS Plus LED-Matrix headlights also include the
PDLS Plus functions.
Dynamic high beam
Fig. 110: Windscreen camera
Light sources and other road users can be detected
by means of the camera (A). Depending on the po-
sition of other vehicles, the speed and other envi-
ronmental and traffic conditions, the individual LED
segments of the high beam headlights are activated

Related Topics

Popular Owner Manuals