2025-2026 Porsche Taycan 2 Door 12-volt battery -> Charging the 12 V battery using the charger User Manual
MyCarUserManual.com
USER MANUALS FOR EVERY MAKE & MODEL

12-volt battery -> Charging the 12 V battery using the charger for Your Porsche Taycan 2 Door Second Generation (2025-2026)

A
B
C
D
E
F
G
H
I
J
K
L
M
N
O
P
Q
R
S
T
U
V
W
X
Y
Z
12-volt battery
283
Disposal
Hand in the old battery at a battery col-
lection point.
Never dispose of an old battery with do-
mestic waste.
Always have maintenance work carried
out by qualified technicians
Never attempt to replace the 12 V lith-
ium battery yourself. The 12 V lithium
battery of this vehicle must only be re-
placed with a 12 V lithium battery ex-
plicitly specified by Porsche for this
vehicle. The use of other 12 V lithium or
lead-acid batteries will result in consid-
erable malfunctions, including total fail-
ure of the electrical system.
Always have the 12 V lithium battery re-
placed by a qualified specialist work-
shop. Porsche recommends a Porsche
partner as they have trained workshop
personnel and the necessary parts and
tools.
12 V lithium battery
What do I
want to do?
What do I have to do?
Avoid run-
ning down
the battery
e Switch off unneeded electri-
cal loads on short trips.
Prepare for
winter
driving
e Have the 12 V lithium battery
checked before the start of
winter.
What do I
want to do?
What do I have to do?
Charging
the 12 V
lithium
battery
e Never charge a damaged 12 V
lithium battery.
Lay up the
vehicle
e If the vehicle is left for long
periods in the garage or
workshop, the doors and lids
of the vehicle should be
closed.
e Turn off the vehicle.
Information
The 12 V lithium battery still discharges even when
your vehicle is not in use.
e To maintain its function, charge the 12 V lithium
battery approximately every 6 weeks or connect
it to a trickle charger suitable for lithium bat-
teries with a CC/CV or pure CV characteristic.
Porsche recommends Porsche Tequipment
chargers and trickle chargers.
Charging the 12 V battery using the charger
Fig. 225: 12 V lithium battery terminals
CAUTION
Escaping irritating gases
due to a damaged 12 V
lithium battery
The use of non-approved chargers or boosters can
result in the 12 V lithium battery being charged with
excessive charging voltage and excessive charging
current. This can damage the 12 V lithium battery,
and irritating gases can escape. This can cause con-
siderable damage to the vehicle and burns.
e Only use chargers or boosters that have been
approved by the equipment manufacturer for
LiFePO
4
batteries with integrated electronic
protection circuits.
e The following maximum values must never be
exceeded:
A
B
C
D
E
F
G
H
I
J
K
L
M
N
O
P
Q
R
S
T
U
V
W
X
Y
Z
12-volt battery
284
– Max. charging voltage: 14.8 V (even in the
event of a fault with the 12 V lithium battery
disconnected; no voltage peaks permitted)
– Max. charging current: 90 A
e If in doubt, contact your Porsche partner.
e Observe the instructions of the charger
manufacturer.
e Ensure adequate ventilation when charging the
12 V lithium battery.
1. Open the bonnet.
> Please refer to chapter "Opening and closing
the bonnet and tailgate" on page 153.
2. Remove the plastic refer to
chapter "Installing and removing the plastic cov-
er in the front luggage compartment" on
page 155.
3. Fold open the cap on the positive terminal for
jump-lead starting +.
4. Connect the red positive cable of the charger to
the positive terminal for jump-lead starting +.
5. Connect the black negative cable of the charger
to the ground point –.
6. Switch on the charger.
7. After charging the battery, first switch off the
charger and then disconnect it.
8. Close the cap on the positive terminal for jump-
lead starting +.
9. Install the plastic cover. Please refer to
chapter "Installing and removing the plastic cov-
er in the front luggage compartment" on
page 155.
For recommendations on a suitable charger:
e Contact your Porsche partner.
Supplying external power from another
vehicle
WARNING
Unsuitable jump leads
and incorrect procedures
Supplying external power using unsuitable jump
leads or following incorrect procedures can cause
short circuits. Short circuits can cause fires.
e Use only standard jump leads with sufficient
cross section and completely insulated terminal
clamps. Follow the instructions provided by the
jump lead manufacturer.
e The vehicles must not touch, otherwise current
may flow as soon as the positive terminals are
connected.
e Ensure that conductive jewellery (e.g. rings,
chains, watch straps) does not come into contact
with live parts of the vehicle.
e Never connect jump leads directly to the 12 V
lithium battery or other electrical components.
Only connect jump leads to the jump-lead start-
ing terminals.
NOTICE
Exhaustively discharged
12 V lithium battery
Risk of damage when supplying external power to an
exhaustively discharged 12 V lithium battery.
e If you suspect that the 12 V lithium battery is
exhaustively discharged, do not supply power
from an external source.
NOTICE
External power supply or
emergency starting
Emergency starting and supplying external power
can severely damage the vehicle electronics.
e Do not supply external power or initiate emer-
gency starting.
e Contact a qualified specialist workshop. Porsche
recommends a Porsche partner as they have
trained workshop personnel and the necessary
parts and tools.
1. Open the bonnet. Please refer to
chapter "Perform emergency unlocking of the
bonnet" on page 58.
2. Remove the plastic cover. Please refer to
chapter "Installing and removing the plastic cov-
er in the front luggage compartment" on
page 155.
Fig. 226: 12 V lithium battery terminals

Related Topics

Popular Owner Manuals