ELECTRIC WINDOWS (2/2)
One-touch electric windows
(continued)
Note: if the window detects resistance
when closing (e.g. tree branch etc.), it
stops and then lowers again by a few
centimetres.
Remote control window
closing
Operating faults
In case of a fault when closing a
window, the system reverts to normal
mode: pull the switch concerned up as
often as necessary to fully close the
window (the window will close gradu-
ally), hold the switch (still on the clos-
ing side) for one second then lower and
raise the window fully to reinitialise the
system.
When the doors are locked from the
outside, if you double-press the lock-
ing button on the driver’s door in
hands-free mode, on the card or, de-
pending on the vehicle, on the key,
all of the windows (and sunroof de-
pending on the vehicle) equipped with
a one-touch electric window will close
automatically.
It is recommended that the user only
operates the system when the vehi-
cle can be seen clearly and no one is
inside.
Impossible to operate the
one-touch electric window
The one-touch electric window is
equipped with heat protection: if you
press the switch for the window more
than 16 consecutive times it goes into
protection mode (locking the window).
If necessary, contact an approved
Dealer.
You can:
– use the electric window switch briefly
and with intervals of approximately
30 seconds;
– with the engine running, the window
will be unlocked after approximately
20 minutes of inaction on the electric
window switch.
When closing the windows, ensure that no part of the body (arm, hand,
etc.) is protruding from the vehicle.
Risk of serious injury.
3.21
English 
