2019-2025 Renault Clio 4 Door Practical Advice -> Tyres User Manual
MyCarUserManual.com
USER MANUALS FOR EVERY MAKE & MODEL

Practical Advice -> Tyres for Your Renault Clio 4 Door Fifth Generation (2019-2025)

TYRES (1/3)  
Tyre and wheel safety  
When the tyre tread has been worn  
to the level of the warning strips, they  
become visible 2: it is then neces-  
sary to replace your tyres because the  
tread rubber is now only 1.6 mm deep  
at most, resulting in poor road hold-  
ing on wet roads.  
The tyres are the only contact between  
the vehicle and the road, so it is essen-  
tial to keep them in good condition.  
2
You must make sure that your tyres  
con- form to local road traffic regula-  
tions.  
An overloaded vehicle, long journeys  
by motorway, particularly in very hot  
weather, or continual driving on poorly  
surfaced minor roads will lead to more  
rapid tyre wear and affect safety.  
1
Maintaining the tyres  
The tyres must be in good condition  
and the tread form must have sufficient  
depth; tyres approved by our Technical  
Department have wear warning strips 1  
which are indicators moulded into  
the tread at several points.  
Incidents which occur when  
driving, such as striking the  
kerb, may damage the tyres  
and wheel rims, and could  
also lead to misalignment of the  
front or rear axle geometry. In this  
case, have the condition of these  
checked by an approved dealer.  
5.11  
 
TYRES (2/3)  
Pressures should be checked when the  
tyres are cold; ignore higher pressures  
which may be reached in hot weather  
or following a fast journey.  
Vehicle fitted with a tyre pressure  
loss warning system  
Tyre pressures  
Adhere to the tyre pressures (including  
the emergency spare wheel). The tyre  
pressures should be checked at least  
once a month and additionally before  
any long journey (refer to the label af-  
fixed to the edge of the driver’s door).  
In the event of under-inflation (punc-  
tures, under-inflation etc.), the  
warning light appears on the instrument  
panel. 2.38.  
If tyre pressures cannot be checked  
when the tyres are cold, assume an in-  
crease of 0.2 to 0.3 bar (or 3 PSI).  
Never deflate a hot tyre.  
Emergency spare wheel  
5.2, 5.9.  
Changing wheels around  
This practice is not recommended.  
Incorrect tyre pressures  
lead to abnormal tyre wear  
and unusually hot running.  
These are factors which  
may seriously affect safety and lead  
to:  
– poor road holding;  
– risk of bursting or tread separa-  
tion.  
Please be aware that a  
poorly tightened or miss-  
ing valve cap can make the  
tyres less airtight and lead  
to pressure loss.  
The pressure depends on the load  
and the speed of use. Adjust the  
pressure according to the condi-  
tions of use (refer to the label affixed  
to the edge of the driver’s door).  
Always use valve caps identical to  
those fitted originally and tighten  
them fully.  
5.12  
 
TYRES (3/3)  
Snow or Winter tyres  
Fitting new tyres  
Use in winter  
We would recommend that these be  
fitted to all four wheels to ensure that  
your vehicle retains maximum adhe-  
sion.  
Chains  
For safety reasons, fitting snow  
chains to the rear axle is strictly for-  
bidden.  
Warning: These tyres sometimes have  
a specific direction of rotation and a  
maximum speed index which may be  
lower than the maximum speed of your  
vehicle.  
Chains cannot be fitted to tyres which  
are larger than those originally fitted to  
the vehicle.  
For your safety, please re-  
spect the speed limit.  
One-way tyres  
Studded tyres  
When they need to be re-  
placed, only tyres of the  
same make, size, type and profile  
should be used on a single axle.  
An one-way tyre must only be fitted in  
one direction. You must observe this di-  
rection.  
This type of equipment may only be  
used for a limited period and as laid  
down by local legislation. It is neces-  
sary to observe the speed specified by  
current legislation.  
If an one-way tyre must be fitted in the  
opposite to its direction of rotation fol-  
lowing a puncture, drive with caution,  
particularly on a wet road, because the  
tyre specifications will not be adapted.  
They must either have a load ca-  
pacity and speed rating at least  
equal to those of the original  
tyres, or be recommended by an  
authorised dealer.  
These tyres must, at a minimum, be  
fitted to the two front wheels.  
Failure to heed these instructions  
could endanger your safety and  
affect your vehicle’s roadworthi-  
ness.  
Risk of loss of control of the ve-  
hicle.  
In all cases, we would recommend  
that you contact an approved Dealer  
who will be able to advise you on  
the choice of equipment which is  
most suitable for your vehicle.  
Chains may only be fitted  
to tyres of the same size  
as those originally fitted to  
your vehicle.  
5.13  
 

Related Topics

Popular Owner Manuals