2009-2016 Renault Megane SUV Getting to know your vehicle -> Exterior lighting and signals User Manual
MyCarUserManual.com
USER MANUALS FOR EVERY MAKE & MODEL

Getting to know your vehicle -> Exterior lighting and signals for Your Renault Megane SUV Third Generation (2009-2016)

EXTERIOR LIgHTINg ANd sIgNALs (1/3)  
daytime running lights  
function  
1
Depending on the vehicle, the daytime  
running lights come on automatically  
when the engine is started. To activate  
or deactivate this function, refer to the  
information on the “Vehicle settings  
customisation menu” in Section 1.  
1
2
3
main beam headlights  
á
With the dipped beam head-  
lights lit, pull stalk 1 towards you. This  
indicator light on the instrument panel  
comes on.  
To return to the dipped headlight posi-  
tion, pull stalk 1 towards you again.  
side lights  
Turn the ring 2 until the symbol  
is opposite mark 3. This indicator light  
on the instrument panel comes on.  
dipped beam  
headlights  
u
k
manual operation  
Turn the ring 2 until the symbol is oppo-  
site mark 3. This indicator light on the  
instrument panel comes on.  
Before driving at night,  
check that the electrical  
equipment is operating cor-  
Automatic operation  
(depending on vehicle)  
rectly and adjust the head-  
Turn ring 2 until theAUTO symbol is op-  
posite mark 3: with the engine running,  
the dipped beam headlights switch on  
or off automatically depending on the  
brightness of the light outside, without  
any action on stalk 1.  
light beams (if your vehicle is not  
carrying its normal load). As a gen-  
eral precaution, check that the lights  
are not obscured (by dirt, mud,  
snow or objects being transported).  
1.71  
EXTERIOR LIgHTINg ANd sIgNALs (2/3)  
special note:  
– If the dipped beam headlights are  
see-me-home lighting”  
function  
This function allows you to briefly switch  
on the dipped beam headlights (to pro-  
vide light when opening a gate, etc.).  
1
manually switched on and if the light  
is sufficient, the directional head-  
lights will remain fixed;  
2
– If the lights come on automatically  
when cornering, the directional  
headlights will start working from the  
next time the vehicle corners;  
– When the dipped beam headlights  
are switched on with the engine  
running and the vehicle stationary,  
the lights move to reinitialise them-  
selves. If not, there is a system fault.  
With the engine and lights off, and  
ring 2 in position 0, pull stalk 1 towards  
you: the dipped beam headlights come  
on for approximately thirty seconds.  
To increase this duration, you may pull  
the stalk up to four times (total time re-  
stricted to two minutes). The message  
“See-me-home _ _ _”, accompanied by  
the lighting time is displayed on the in-  
strument panel to confirm the action.  
switching off the lights  
There are two possibilities:  
directional headlights  
To switch off the lights before they go  
out automatically, turn ring 2 to any po-  
sition, then return it to position 0.  
Depending on the vehicle, with the  
dipped beam headlights on and under  
certain conditions (speed, steering  
wheel angle, forwards gear selected,  
etc.) when cornering, the dipped beam  
headlights move to light the inside of  
the bend.  
– Manually, move ring 2 to position 0;  
– automatically, the lights will go out  
when the engine is switched off, the  
driver’s door is opened or the vehicle  
is locked. In this case, the next time  
the engine is started the lights will be  
switched back on according to the  
position of the ring 2.  
Operating faults  
When the message “Check lighting”,  
accompanied by the © warning  
light is displayed on the instrument  
panel, there is a lighting fault.  
Note: if the fog lights are lit, the lights  
are not switched off automatically.  
Consult an approved dealer.  
1.72  
EXTERIOR LIgHTINg ANd sIgNALs (3/3)  
front fog lights  
switching off the lights  
g
Turn centre ring 5 on stalk 1  
Turn ring 5 again until mark 6 is oppo-  
site the symbol for the fog light that you  
wish to switch off. The corresponding  
indicator light on the instrument panel  
goes out.  
until the symbol faces mark 6, then re-  
lease it.  
1
5
Operation of the fog lights depends on  
the exterior lighting position selected,  
and an indicator light will light up on the  
instrument panel.  
The front and rear fog lights switch off  
when the exterior lights are switched  
off.  
6
Rear fog light  
Turn centre ring 5 on the stalk  
until the symbol faces mark 6, then re-  
f
lease it.  
Operation of the fog lights depends on  
the exterior lighting selected, and an in-  
dicator light will light up on the instru-  
ment panel.  
Lights-on reminder buzzer  
If the lights are on after the engine is  
switched off, a warning beep sounds  
when the driver’s door is opened to  
warn you that the lights are still on.  
To avoid inconveniencing other road  
users, remember to switch off the rear  
fog light when it is no longer needed.  
When driving in fog or snow, or  
when transporting objects which are  
higher than the roof, the headlights  
do not come on automatically.  
Switching on the fog lights remains  
the responsibility of the driver: the  
indicator lights on the instrument  
panel inform you whether the fog  
lights are lit (indicator light on) or not  
(indicator light not on).  
1.73  

Related Topics

Popular Owner Manuals