ELECTRIC WINDOWS (2/2)
One-touch mode
(depending on vehicle)
Operating faults
If a fault occurs when closing a window,
the system switches to normal mode:
lift the switch concerned as many times
as necessary until the window is fully
closed, release it. Press the switch
again (still on the closing side) for ap-
proximately one second to reset the
system.
This mode works in addition to the
operation of the electric windows de-
scribed previously. It can be fitted to the
driver’s window.
Briefly press or pull the window switch
fully: the window is fully lowered or
raised. Pressing the switch again stops
the window moving.
8
If necessary, contact an approved
Dealer.
Impossible to operate the one-touch
electric window
The one-touch electric window is
equipped with heat protection: if you
press the switch for the window more
than sixteen consecutive times it goes
into protection mode (locking the
window).
Manual window winder
controls
Turn handle 8.
You can:
– use the electric window switch briefly
and with intervals of approximately
30 seconds;
– with the engine running, the window
will be unlocked after approximately
20 minutes of inaction on the electric
window switch.
When closing the windows,
ensure that no part of the
body (arm, hand, etc.) is
protruding from the vehicle.
Note: if the window detects resistance
when closing (e.g.: branch of a tree,
etc.) it stops and then lowers again by a
few centimetres.
Risk of serious injury.
3.17
English 
