ParPkainrgkiangidasnydstmeman(oPeaurkvrAinsgsist)
or ParkPilot to give erroneous warnings. The
presence of metal objects can also aꢀect
the manoeuvre.
●
If you use high-pressure or vapour equip-
WARNING
ment to clean the ultrasound sensors, do not
apply it directly unless very briefly and al-
ways from a distance of more than 10 cm.
Quick turns of the steering wheel when park-
ing or exiting a parking space with Park As-
sist can cause serious injury.
●
In order to become familiar with the system
and its functions, SEAT recommends that you
practice operating the Park Assist system in
an area where there is not too much trac or
in a car park.
●
A registration plate or plate holder on the
●
Do not hold the steering wheel during ma-
front with larger than the space for the reg-
istration plate, or a registration plate that is
curved or warped can cause:
noeuvres to park or exit a parking space un-
til the system requests it. Doing so disables
the system during the manoeuvre, resulting
in the parking being cancelled.
–
–
–
False detections.
Description of the parking assist sys-
tem
The sensors to lose visibility.
Cancellation of the parking manoeuvre
NOTICE
or defective parking.
●
In certain circumstances, the ultrasonic
●
If one of the ultrasonic sensors is dam-
sensors do not detect objects such as trailer
tongues, bars, fences, posts or thin trees, or
an open (or opening) rear lid, which could
damage the vehicle.
aged, the area corresponding to that group
of sensors (front or rear) is deactivated and
cannot be activated until the fault is correc-
ted. However, you can still use the sensors
of the other bumper as per usual. If there
is a fault in the system, consult a specialist
workshop. SEAT recommends visiting a SEAT
dealership for this.
●
Retrofitting of certain accessories to the
vehicle, such as a bicycle rack, may interfere
with the operation of the Park Assist system
and cause damage.
●
The Park Assist system uses as a reference
parked vehicles, curbs and other objects.
Make sure that the tyres and wheels are not
damaged while parking. If necessary, oppor-
tunely interrupt the parking manoeuvre to
avoid damaging the vehicle.
Fig. 125 In the centre console: button to switch
on the Park Assist system.
Note
●
In order to guarantee good system oper-
ation, keep the ultrasound sensors of the
bumper clean, free of snow or ice, and do not
cover them with adhesives or other objects.
The components of the Park Assist system are
the ultrasonic sensors located in the front and
rear bumpers, the button to switch the sys-
tem on and o and the messages on the instru-
ment panel display.
●
The ultrasound sensors on the bumper may
be damaged or shifted in the event of a colli-
sion, for example, when entering or exiting a
parking space.
●
Certain sources of noise, such as rough as-
phalt or paving stones and the noise of other
vehicles can induce the Park Assist system
167