ParkiRnegaarnpdamrkainngoaeiudvring
Temporary sound suppression
Make particularly sure that the sensors are not
covered by adhesives, residues, dirt and the
like, as this could aect the system's operation.
Cleaning instructions ››› page 305.
If the fault doesn't disappear before discon-
necting the ignition, it will not be indicated next
time the parking aid is connected.
●
Press the
function button on the infotain-
ment screen.
If there is a fault in a sensor, the symbol is
displayed on the infotainment system display.
The approximate measurement range of the
rear sensors is:
Change from reduced view to full view
We recommend taking the vehicle to a special-
ised workshop to have the fault repaired.
●
●
Select reverse gear.
●
●
Side area: 0.60 m
OR: on vehicles fitted with reverse assist
Central area: 1.60 m
(Rear View Camera “RVC”) press on the car
icon of the reduced display.
Towing device
As you approach the obstacle, the frequency of
the audible signals will increase. The signal will
sound continuously at around 0.30 m: Stop the
In vehicles equipped with a towing bracket de-
vice from the factory, when the trailer is con-
nected, the parking aid will not be activated
when reverse gear is engaged.
Switch to the reverse assist image (Rear
View Camera “RVC”)
vehicle! ›››
on page 162.
If the separation is maintained, the warning vol-
ume is reduced after about 4 seconds.
●
●
Select reverse gear.
OR: press the “RVC” function button.
WARNING
Parking Aid connection
Observe the safety warnings ›››
scription on page 162.
in De-
Parking assist settings
●
Select reverse gear.
The audio indications and signals are set in the
infotainment system ››› page 35:
Parking Aid disconnection
●
●
Rear volume:Volume in the rear area.
●
●
Drive forward at 15 km/h (9 mph) or faster.
Reduce volume:When the parking aid is
OR: place the selector level in position P, N
switched on, the volume of the audio source will
be reduced, depending on the selected option.
or D (for automatic gearboxes) or disengage
reverse (for manual gearboxes).
●
Rear sound settings/treble:Sound
tone in the rear area.
Set the lever to the N or D position to maintain
the system active for approximately 8 seconds
before switching o. During this time, the Park-
ing aid will be deactivated if the selector lever is
set to P.
Error messages
If a an error or fault message appears on the in-
strument panel in Parking assist, there is a fault.
165