2016-2020 Seat Ateca SUV Infotainment System -> Operating modes User Manual
MyCarUserManual.com
USER MANUALS FOR EVERY MAKE & MODEL

Infotainment System -> Operating modes for Your Seat Ateca SUV First Generation (2016-2020)

Lights and visibility  
Closing the sunroof or sun blind without  
the anti-trap function  
It lights up  
Lights and visibility  
Trailer turn signals  
Sunroof: within approximately 5 seconds of  
Lights  
having activated the roll-back function, press  
It lights up  
the button››› Fig. 148 to the second level  
Related video  
D
in the direction of arrow››› Fig. 148  
until  
Main beam on or flasher on››page 150.  
the sunroof closes completely.  
Sun blind: within approximately 5 seconds  
It lights up  
of having activated the anti-trap function,  
The Light Assist system is on››page 152.  
2
press button››› Fig. 149  
until the sun blind  
closes completely.  
Several warning and control lamps light up  
for a few seconds when the ignition is switch-  
ed on, signalling that the function is being  
verified. They will switch off after a few sec-  
onds.  
The sunroof or sun blind close without  
the anti-trap function intervening!  
Fig. 151 Vehicle lights  
If the sunroof or sun blind will still not close,  
visit a specialised workshop.  
Control lamps  
WARNING  
WARNING  
It lights up  
Closing the sunroof or sun blind without the  
anti-trap function can cause serious inju-  
ries.  
Observe the safety warnings››› in Con-  
trol and warning lamps on page 124.  
Driving light totally or partially faulty.  
Fault in the cornering light system.  
Always be careful when closing the sun-  
roof and sun blind.  
Side light and dipped beam head-  
light  
It lights up  
No person should ever remain in the way  
of the sunroof or sun blind, especially when  
closing without the anti-trap function.  
Rear fog light switched on››page 153.  
Read the additional information carefully  
page 33  
The anti-trap function does not prevent  
›››  
It lights up  
fingers or other parts of the body from be-  
coming trapped against the roof frame and  
injuries occurring.  
The driver is personally responsible for the  
correct use and adjustment of the lights in all  
situations.  
Left or right turn signal.  
The control lamp flashes twice as fast when a turn  
signal is faulty.  
»
Hazard warning lights on››page 154.  
149  
Operation  
Audible warnings to advise the driver that  
the lights have not been switched off  
Note  
On vehicles with rear lights with bulbs,  
when activating the daytime running light  
the rear lights are not switched on. A vehi-  
cle which does not have the rear lights on  
may not be visible to other drivers in the  
darkness, in the case of heavy rain or in  
conditions of poor visibility.  
The legal requirements regarding the use  
of vehicle lights in each country must be  
observed.  
If the key is not in the ignition and the driver  
door is open, an audible warning signal is  
heard in the following cases: this will remind  
you to turn the light off.  
Daytime running lights  
When the parking light is on››› page 150.  
When the light switch is in position or .  
The daytime running lights consist of individu-  
al lights, integrated in the front headlights. By  
connecting the daytime running lights, these  
Turn signal and main beam lever  
WARNING  
Read the additional information carefully  
lights are switched on1) ›››  
.
The side lights or daytime running lights  
are not bright enough to illuminate the road  
ahead and to ensure that other road users  
are able to see you.  
page 34  
›››  
The daytime running lights switch on every  
time the ignition is switched on, if the switch is  
in positions or , according to the level of  
exterior lighting.  
Push the lever all the way down to turn off the  
corresponding function.  
Always use your dipped beam head  
lights if it is raining or if visibility is poor.  
Convenience turn signals  
When the light switch is in position , a light  
sensor automatically switches dipped beam  
on and off (including the control and instru-  
ment lighting) or the daytime running lights  
depending on the level of exterior lighting.  
For the one-touch signalling, when the igni-  
tion is switched on, move the lever as far as  
possible upwards or downwards and release  
the lever. The turn signal will flash three times.  
WARNING  
If the headlights are set too high and not  
used correctly, there is a risk of dazzling or  
distracting other road users. This could re-  
sult in a serious accident.  
One-touch signalling is activated and deacti-  
vated in the Easy Connect system via the   
button and the function button SETTINGS >  
Lights > One-touch signalling  
WARNING  
Always make sure that the headlights are  
Never drive with daytime lights if the road  
correctly adjusted.  
is not well lit due to weather or lighting  
conditions. Daytime lights do not provide  
enough light to illuminate the road properly  
or be seen by other road users.  
›››  
page 36.  
1)  
On vehicles equipped with rear LED lights, the  
rear side light is switched on as well.  
150  
Lights and visibility  
In vehicles that do not have the correspond-  
ing menu, this function can be deactivated in  
a specialised workshop.  
If a trailer turn signal malfunctions, the  
Automatic switch-  
ing on  
Automatic switch-  
ing off  
control lamp will stop flashing (trailer turn  
signals) and the vehicle turn signal will  
flash at double speed.  
The rain sensor detects  
rain and activates the  
windscreen wipers.  
When the windscreen  
wipers have been inac-  
tive for a few minutes.  
WARNING  
The main beam headlights can only be  
switched on if the dipped beam headlights  
are already on.  
Improper or lack of use of the turn signals,  
or forgetting to deactivate them can con-  
fuse other road users. This could result in a  
serious accident.  
WARNING  
If the road is not well lit and other road  
users cannot see the vehicle well enough  
or at all, accidents may occur.  
In cold or damp weather conditions, the  
headlights, tail lights and turn signals may  
mist up inside temporarily. This is normal  
and in no way effects the useful life of the  
vehicle lighting system.  
Always give warning when you are going  
to change lane, overtake or when turning,  
activating the turn signal in good time.  
The automatic dipped beam control  
() only switches on the dipped beam  
when there are no changes in brightness,  
and not, for example when it is foggy.  
As soon as you have finished changing  
lane, overtaking or turning, switch the turn  
signal off.  
Automatic dipped beam control  
*  
WARNING  
Main beam assist (Light Assist)*  
The automatic dipped beam control is merely  
intended as an aid and is not able to recog-  
nise all driving situations.  
Incorrect use of the headlights may cause  
accidents and serious injury, as the main  
beam may distract or dazzle other drivers.  
The main beam assist acts within the limits of  
the system and depending on environmental  
and traffic conditions. Once switched on, the  
system is activated as of a speed of about 60  
km/h (37 mph) and is deactivated below  
When the light switch is in position , the  
vehicle lights and the instrument panel and  
switch lighting switch on and off automatical-  
ly in the following situations››› in Daytime  
running lights on page 150:  
Note  
If the convenience turn signals are oper-  
about 30 km/h (18 mph)›››  
.
ating (three flashes) and the other conven-  
ience turn signals are switched on, the ac-  
tive part stops flashing and only flashes  
once in the new part selected.  
When the system is activated and the cam-  
era detects other vehicles that may be daz-  
zled, the main beam is automatically switch-  
ed off. Otherwise, the main beam is automati-  
cally switched on.  
Automatic switch-  
ing on  
Automatic switch-  
ing off  
The turn signal only works when the igni-  
tion is switched on. The hazard warning  
lights also work when the ignition is switch-  
ed off.  
The photo sensor de-  
When adequate lighting  
tects darkness, for exam- is detected.  
ple, when driving through  
a tunnel.  
The main beam assist generally detects illu-  
minated areas and deactivates the main  
»
151  

Related Topics

Popular Owner Manuals