2021-2026 Seat Ibiza SUV Unlocking and locking -> Anti-theft alarm system* User Manual
MyCarUserManual.com
USER MANUALS FOR EVERY MAKE & MODEL

Unlocking and locking -> Anti-theft alarm system* for Your Seat Ibiza SUV Fifth Generation (2018-2026)

Unlocking and locking  
79  
–
–
Maximum time allowed for synchronising is 30 seconds.  
Anti-theft alarm system*  
The normal key is used to activate the ignition, and the key with  
the remote control is the key to be programmed.  
Description of anti-theft alarm system*  
–
–
Check that the car is open before commencing programming.  
The anti-theft alarm triggers an alarm if unauthorised move-  
ments are detected around the vehicle.  
Place the key without remote control in the contact inside the  
steering and ignition lock.  
The anti-theft alarm makes it more difficult to break into the vehicle or steal  
it. Audible and visible alarms are triggered if the car is opened using the  
mechanical key, or if unauthorised access is gained to the vehicle.  
–
–
–
–
Use the key with remote control and mechanically lock the  
vehicle from the driver's door.  
The anti-theft alarm system is automatically switched on when the vehicle is  
locked. To lock the door either turn the key once in the lock towards the  
Open and close the driver's door lock mechanically, using the  
remote control key.  
2
locking position or press button  
A on the radio-frequency remote  
control*. The system is activated immediately and the indicator light located  
on the driver's door will flash along with the indicators indicating that the  
alarm and the locking security system (double lock) have been turned on.  
1
At the same time press the button  
key.  
Aon the remote control  
When the vehicle is locked the indicator lamps light up only if the alarm has  
been correctly activated (all the protection zones should be correctly closed).  
Complete the procedure by removing the key from the contact  
If any of the doors or the bonnet are open, when the alarm is connected these  
will not be included in the protection zones of the vehicle. If the door or  
bonnet is subsequently closed, they will automatically be included in the  
vehicle protection zones and the indicators will flash accordingly.  
It is possible that the vehicle could no longer be opened and closed with the  
remote control if the button  
is repeatedly pressed outside of the effective  
range of the radio frequency remote control. The remote control key will have  
to be resynchronised.  
Spare remote control keys are available from Authorised Service Centres, they  
must be matched to the locking system.  
When does the system trigger an alarm?  
The alarm system is triggered, in the locked vehicle, when:  
•
•
•
a door  
the bonnet or  
the tailgate  
are unduly opened  
or the ignition is switched on  
•
Safety First  
Operating instructions  
Tips and Maintenance  
Technical Data  
80  
Unlocking and locking  
The horn is sounded and the turn signals flash for approx. 30 seconds.  
Volumetric sensor*  
How is the alarm switched off?  
Monitoring or control function incorporated in the anti-theft  
alarm*, that detects unauthorized vehicle entry using ultra-  
sound.  
To deactivate the anti-theft alarm, rotate the key in the opening direction or  
press the button  
on the remote control.  
•
•
The indicator light flashes twice on opening and the alarm is deactivated.  
The indicator light flashes once on closing and the alarm is activated.  
The system consists of 3 sensors, 2 emitters and a receptor.  
In vehicles equipped with an additional* alarm system, if the vehicle is  
opened using the driver's door key, you have 15 sec to insert the key in the  
ignition lock and activate the ignition. Otherwise, the alarm will go off for 30  
sec. and the ignition will be blocked.  
Activation  
–
It is automatically turned on with the anti-theft alarm, when the  
vehicle is locked mechanically with the key and when the button  
on the remote control is used.  
In vehicles with keys without remote control it is necessary to wait 30 seconds  
until the alarm stops. Then lock the vehicle using the key and repeat the  
above process.  
Deactivation  
3)  
–
–
Open the vehicle with the key, either mechanically or by  
If the vehicle is opened at any door other than the driver's door or the tailgate  
the alarm will go off for 30 seconds.  
pressing the button  
on the remote control.  
Press the button  
on the remote control twice. Only the volu-  
metric sensor is deactivated. The alarm system remains acti-  
vated.  
Note  
•
After 28 days the indicator light will switch off to prevent the battery  
running down where the vehile has been left parked for a long period of time.  
The alarm system remains activated.  
The interior monitoring system will be switched on automatically with the  
anti-theft alarm. All of the doors and the tailgate must be closed to activate  
the sensor of the interior monitoring system.  
•
If, after the alarm has stopped, attempts are made to open another  
protection zone, the alarm will be triggered again.  
The alarm system can be activated or deactivated using the remote  
control ⇒ page 77.  
The interior monitor should be switched off, if for example animals are briefly  
left in the locked vehicle. Their movements could otherwise trigger an alarm.  
•
The interior monitor should also be deactivated if the windows are left  
slightly open, otherwise the alarm may be triggered due to the effect caused  
by wind entering the vehicle.  
3)  
The time period from when the door is opened until the key is inserted in the contact  
should not exceed 15 sec., otherwise the alarm will be triggered.  
Unlocking and locking  
81  
Note  
•
If, after deactivating the volumetric sensor, the vehicle is locked using the  
remote control or the key in the door lock in under 30 seconds, the volumetric  
sensor will remain deactivated. The other functions of the antitheft alarm*  
will remain activated. After this time, the deactivation function of the volu-  
metric sensor is cancelled.  
•
If the vehicle is relocked and the alarm is activated without the volumetric  
sensor function, relocking will activate the alarm with all its functions, except  
the volumetric sensor. This function is reactivated when the alarm is next  
switched on, unless it is deliberately switched off.  
•
If the alarm has been triggered by the volumetric sensor, this will be indi-  
cated by a flashing of the indicator on the driver's door. The flash is different  
to the flash indicating the alarm is activated.  
•
If the alarm is triggered three times by the volumetic sensor, the alarm  
system is no longer triggered.  
Triggering caused by other sensors (doors, boot opening, etc.) will  
continue  
•
Safety First  
Operating instructions  
Tips and Maintenance  
Technical Data  

Related Topics

Popular Owner Manuals