Unlocking and locking
85
The one-touch function and roll-back function will not work if there is a
malfunction in the electric windows. Contact an Authorised Service Centre.
–
Use the key to lock the vehicle from outside and hold the key in
the lock position for at least one second. The one-touch function
is now ready for operation.
WARNING
1
2
The buttons ⇒ page 83, fig. 52 A and A have two levels for opening the
window and two for closing it. This makes it easier to open or close windows
to the desired position.
•
•
Incorrect use of the electric windows can result in injury.
Always take the key with you when leaving the vehicle, even if you only
intend to be gone for a short time. Please ensure that children are never left
unsupervised in the vehicle.
One-touch closing does not work when the ignition has been switched off,
even if the key is in the ignition.
•
The electric windows will work until the key has been removed from the
ignition and one of the front doors has been opened.
Never close the tailgate without observing and ensuring it is clear, to do
The automatic open and close function will not work if the battery has been
temporarily disconnected, or if the battery is flat. The function then has to be
reactivated.
•
otherwise could cause serious injury to you and others. Make sure that no
one is in the path of a window.
The one-touch function and roll-back function will not work if there is a
malfunction in the electric windows. Contact an Authorised Service Centre.
•
Never allow people to remain in the vehicle when you close the vehicle
from the outside. The windows cannot be opened even in an emergency.
Roll-back function
Note
The roll-back function is deactivated if the windows are closed from the
outside of the vehicle using the ignition key for convenience closing
⇒ page 85.
The windows have a roll-back function. This reduces the risk
of injuries when the windows are closing.
•
If a window is obstructed when closing automatically, the window stops
at this point and lowers immediately ⇒
If this happens, check immediately (within 10 seconds) why the window
.
Convenience opening and closing*
Using the door lock
•
could not be closed before attempting to close it again. After 10 seconds the
normal automatic function resumes.
•
•
If the window is still obstructed, the window stops at this point.
If there is no obvious reason why the window cannot be closed, try to
–
Hold the key in the door lock of the driver door in either the
locking or the unlocking position until all windows are either
opened or closed.
close it again within five seconds.
If you wait longer than 10 / 5 seconds, the window will open fully when you
operate one of the buttons. One-touch closing is reactivated.
–
Release the key to interrupt this function.
Safety First
Operating instructions
Tips and Maintenance
Technical Data
English 
