Wheels -> Breakdown kit for Your Skoda Fabia 4 Door Third Generation (2014-2020)

Wheels › Breakdown kit 131  
Place the key on the  
wheel bolt or on the  
attachment piece.  
Turn the screw a maxi-  
mum of half a turn so  
that the wheel does  
not come loose and fall  
off.  
NOTICE  
Applies to factory installed or from ŠKODA Origi-  
nal wheel covers supplied: Install the anti-theft  
wheel bolt according to the position marked on the  
back of the wheel cover.  
Tighten screws  
Tighten the opposite wheel bolts including the an-  
ti-theft wheel bolt one after the other.  
Reinstall the cover caps of the wheel bolts or the  
full wheel covers.  
Pickups for the jack  
Keep the label with the code number of the anti-  
theft wheel bolts. Based on this, a replacement at-  
tachment piece can be purchased from the ŠKODA  
Original parts.  
Breakdown kit  
Content overview  
The kit is located in a box under the floor covering in  
the luggage compartment.  
A
B
16 cm  
22 cm  
Position the jack and raise the vehicle  
Use the jack from the tool kit.  
A
B
C
D
Stickers with the speed indication  
Valve insert driver  
Filling hose with sealing plug  
Air compressor (the layout of the controls may  
be different depending on the type of air com-  
pressor)  
Position the jack at the jacking point closest to the  
wheel to be replaced.  
Insert the crank into the mount on the car jack.  
Support the base plate of the jack with its full area  
resting on level ground and ensure that the jack is  
located in a vertical position at the jacking point.  
Use the crank to raise the jack until its claw enclo-  
E
F
G
H
I
Tyre inflation hose  
Button for pressure reduction  
Pressure display  
12 volt cable connector  
ON and OFF switch  
Tyre inflation bottle  
ses the bar.  
Continue to lift the vehicle until the wheel is just  
off the floor.  
J
K
Replacement valve core  
Changing a wheel  
Unscrew the screws and place them on a clean  
surface.  
Remove the wheel carefully.  
Attach the wheel.  
Slightly screw in the screws.  
Lower the vehicle.  
The declaration of conformity is included with the air  
compressor or the log folder.  
Conditions of use  
Performing a repair with the breakdown kit not at all  
intended to replace a permanent repair on the tyre.