Wheels › Breakdown kit 131
Changing a wheel
The declaration of conformity is included with the air
compressor or the log folder.
Unscrew the screws and place them on a clean
›
surface.
Remove the wheel carefully.
Attach the wheel.
Slightly screw in the screws.
Lower the vehicle.
›
Usage conditions
›
›
›
Performing a repair with the breakdown kit not at all
intended to replace a permanent repair on the tyre.
The purpose of the repair is to get you to the nearest
specialist garage.
NOTICE
Applies to wheel trims supplied ex-factory or from
ŠKODA Original Accessories: the anti-theft wheel
bolt should be installed in the position marked on
the back of the wheel trim.
▶
Change the tyre repaired by the breakdown kit as
soon as possible.
Before using the kit
Tighten screws
Tighten the opposite wheel bolts including the an-
ti-theft wheel bolt one after the other.
Reinstall the cover caps of the wheel bolts or the
Park the vehicle securely and secure it from rolling
away.
›
›
Turn off the engine.
Let all of the occupants get out. During the wheel
repair they should not stand on the road, e.g. be-
hind the crash barriers.
›
›
›
full wheel covers.
Keep the label with the code number of the anti-
theft wheel bolts. A replacement upper section can
be acquired from ŠKODA original parts based on
this.
Close all doors as well as the bonnet and boot lid.
Uncouple any trailers.
›
›
After using the kit
If a tyre pressure of 2.0 bar cannot be achieved, the
tyre is too damaged and cannot be sealed with the
puncture set.
Breakdown kit
Content overview
Stop driving. Seek the help of a specialist garage.
›
The kit is located in a box under the floor covering in
the luggage compartment.
Once a tyre pressure of 2.0–2.5 bar is achieved, con-
tinue the journey at a maximum speed of 80 km/h
(50 mph).
Avoid full accelerations, strong braking and fast
cornering.
›
Information for driving with repaired tyres
The pressure of the repaired tyre must be checked
after driving for 10 minutes.
›
If the tyre pressure is 1.3 bar and less, do not con-
tinue! Seek the help of a specialist garage.
›
If the tyre pressure is higher than 1.3 bar, correct
the pressure to the correct value of at least 2 bar
and continue driving.
›
A
B
C
D
Sticker with speed indication
Valve remover
NOTICE
Inflation hose with plug
Danger of damage to the compressor!
After the maximum running time of the air com-
pressor, allow it to cool for a few minutes.
Air compressor (the layout of the controls may
be different depending on the type of air com-
pressor)
▶
WARNING
Risk of burns!
The tyre inflation hose and the air compressor may
become hot when inflated.
Allow the air compressor and hose to cool for a
few minutes.
E
F
G
H
I
Tyre inflation hose
Button for pressure reduction
Pressure indicator
▶
12 volt cable connector
ON and OFF switch
J
Tyre inflation bottle
Usage restrictions
K
Replacement valve core
Do not use the kit in the following cases:
English 
