132 Wheels › Tyre pressure
The rim is damaged.
Check the pressure when the tyres are cold. Do
not reduce the higher pressure of warm tyres.
After each change in tyre pressure, save the new
values in the tyre control display.
▶
▶
▶
▶
The outdoor temperature is below the minimum
temperature indicated in the manual of the tyre fill-
ing bottle.
Tyre punctures are greater than 4 mm.
There is damage to the tyre wall.
The expiry date stated on the tyre inflation bottle
▶
▶
▶
WARNING
Risk of an accident!
If tyre pressure loss is very quick, try to stop the
vehicle carefully without heavy steering or heavy
braking.
▶
has expired.
Self-help
Sticker with prescribed tyre pressures
Seal the tyres
The sticker with prescribed tyre pressures is located
on the inside of the fuel filler flap.
Unscrew the valve cap from the damaged tyre.
Unscrew the valve core with the valve insert and
place it on a clean surface.
Shake the tyre inflation bottle back and forth with
›
›
Inflation pressure for
half load
A
›
sealant.
Inflation pressure for
environmentally
friendly operation
(slightly lower fuel
consumption and
emissions)
B
Screw the inflation hose onto the tyre inflater bot-
tle. The film on the closure is pierced automatically.
Remove the plug from the inflation hose and push
it fully onto the tyre valve.
Hold the bottle with the bottom facing upwards
and fill all of the sealing agent into the tyre.
Remove the filler plug from the valve.
Screw in the valve insert.
›
›
›
Inflation pressure for
a full load
Tyre diameter in in-
C
D
›
›
ches
Inflate tyres
Fit the tyre inflation hose of the air compressor to
the tyre valve.
Secure the vehicle with the parking brake.
Start the engine.
Plug the connector into the 12 volt socket .
Turn on the air compressor.
Once a tyre pressure of 2.0-2.5 bar is reached, turn
This information only serves as information for
the prescribed tyre pressure. This is not a listing
of approved tyre sizes for your vehicle. These
are in the vehicle's technical documentation, as
well as in the declaration of conformity (in the
so-called COC document).
›
›
›
›
Tyre pressure reading for the front axle tyres
E
F
›
›
Tyre pressure reading for the rear axle tyres
off the air compressor.
Prescribed tyre pressure value for the emergen-
cy wheel
G
Observe the maximum running time of the air com-
pressor according to the directions of the repair kit
manufacturer.
Tyre pressure monitor
Functionality
If an air pressure of 2.0 - 2.5 bar has not been
reached, remove the tyre inflation hose from the
valve.
›
Drive approx. 10 metres forwards or backwards to
allow the sealing agent to distribute in the tyre.
›
The tyre pressure monitoring indicator indicates a
change in tyre pressure.
Replace the tire inflation hose on the valve and re-
peat the inflation procedure.
›
Warning when pressure changes
illuminates
Stop the vehicle.
Check the tyres and tyre pressures.
›
Tyre pressure
›
What you should be mindful of
Show tyres with modified pressure
In the following menu, select the menu item for
displaying the tyre condition:
›
NOTICE
Always adjust the tyre pressure to the load.
▶
▶
Check the pressure in all tyres at least once a
month and before each longer ride.
Or:
English 
