Wheels › Wheel bolt cover caps 133
Troubleshooting
Tyre pressure display faulty
flashes for about 1 minute and stays on
Function restriction
Stop the vehicle, switch off the ignition and
start the engine.
›
The system is unable to provide a warning in the
event of a very rapid tyre pressure loss, e.g. sudden
puncture.
If the symbol flashes again after starting the en-
gine, there is a system fault.
Continue driving, exercising appropriate caution,
and seek the help of a specialist garage.
The system function may be restricted in the follow-
ing cases:
›
Uneven loading of the wheels, e.g. with a trailer at-
tached
▶
Sporty driving style
Driving on dirt roads
Snow chains fitted
▶
▶
▶
Wheel bolt cover caps
Remove cover caps and install
Disconnecting
Saving tyre pressure values
Push the pull-off clamp
onto the cover cap up
to the stop.
›
Store the tyre pressure values in the infotainment
Inflate the tyres to the prescribed inflation pres-
sure.
›
Remove the cover cap.
›
Turn on the ignition.
In the following menu, select the menu item for
displaying the vehicle condition:
›
›
Or:
Installing
Push the cover cap onto the wheel bolt to the stop.
›
Using the functional surfaces
control display menu.
Tap on the functional surface
select the tyre
.
›
›
›
Full wheel frame
Then follow the instructions on the screen.
Removing and installing the trim
Save tyre pressures with the button
Inflate the tyres to the prescribed inflation pres-
sure.
Applies to factory built or original accessory trims
from ŠKODA.
›
Turn on the ignition.
Keep the button pressed down.
›
Disconnecting
›
Hang the clamps for removing the wheel trims at
the edge of one of the openings in the trim.
›
The warning light in the instrument cluster illumi-
nates from the isolation box. After storing the
tyre pressure values, an acoustic signal sounds and
the warning light goes out.
Push the wheel wrench through the clamp, support
on the tyre and pull off the wheel trim.
›
Installing
Release the button
.
›
Press the wheel trim onto the wheel rim at the
designated valve opening.
›
Save the tyre pressures in the following cases:
When using an anti-theft wheel bolt, it must be lo-
cated at the location indicated on the bezel.
Press the trim, starting at the valve, into the rim on
both sides until it engages around the entire cir-
cumference.
Change of tyre pressure
Change of one or more wheels
Change of position of a wheel on the vehicle
Always after covering a distance of 10,000 km or
once a year
▶
▶
▶
▶
›
NOTICE
Use hand pressure, do not hit the wheel cover.
▶
English 
