2000-2004 Subaru Outback SUV Instruments and controls -> Meters and gauges User Manual
MyCarUserManual.com
USER MANUALS FOR EVERY MAKE & MODEL

Instruments and controls -> Meters and gauges for Your Subaru Outback SUV Second Generation (2000-2004)

3
Instruments and controls
3-7
– CONTINUED –
Hazard warning flasher
HB8002BA
The hazard warning flasher is used to warn other drivers when you have
to park your vehicle under emergency conditions. The hazard warning
flasher works with the ignition switch in any position.
To turn on the hazard warning flasher, push the hazard warning button
on the instrument panel. To turn off the flasher, push the button again.
NOTE
When the hazard warning flasher is on, the turn signals do not work.
Meters and gauges
J Speedometer
The speedometer shows the vehicle speed.
J Odometer/Trip meter
CAUTION
To ensure safety, do not attempt to change the function of the in-
dicator during driving, as an accident could result.
3-8
HB3015BB
B Odometer
The odometer shows the total distance that the vehicle has been driv-
en.
B Double trip meter
The trip meter shows the distance that the vehicle has been driven
since you last set it to zero.
To change the mode indication, briefly push the knob.
Each press of the knob changes the function alternately.
A trip meter B trip meter
To set the trip meter to zero, select either the A trip or B trip meter and
push the knob and keep it pushed for more than 1 second.
NOTE
If the connection between the combination meter and battery is bro-
ken for any reason such as vehicle maintenance or fuse replace-
ment, the data recorded on the trip meter will be lost.
3
Instruments and controls
3-9
– CONTINUED –
J Tachometer
CAUTION
Do not operate the engine with the pointer of the tachometer in
the red zone. In this range, fuel injection will be cut by the engine
control module to protect the engine from overrevving. The
engine will resume running normally after the engine speed is
reduced below the red zone.
The tachometer shows the engine speed in thousands of revolutions per
minute.
J Outside temperature indicator (if equipped)
The outside temperature indicator shows the outside temperature in a
range from –22°F to 122°F (–30°C to 50°C).
The indicator can give a false reading under any of the following condi-
tions:
D When there is too much sun.
D During idling; while running at low speeds in a traffic jam; when the
engine is restarted immediately following a shutdown.
D When the actual outside temperature falls outside the specified indi-
cator range.
For vehicles with an automatic climate control, outside temperature
can be displayed on the climate control display panel. Refer to the
“Automatic climate control system” in chapter 4.
J Fuel gauge
The fuel gauge shows the approximate amount of fuel remaining in the
tank.
The gauge does not return to “E” even though the ignition switch is in the
“ACC” or “LOCK” position.
The gauge may move slightly during braking, turning or acceleration due
to fuel level movement in the tank.
3-10
J Temperature gauge
CAUTION
If the pointer exceeds the normal operating range, safely stop the
vehicle as soon as possible.
See “In case of emergency” in chapter 9.
HB2012BB
The temperature gauge shows engine coolant temperature when the
ignition switch is in the “ON” position.
The coolant temperature will vary in accordance with the outside temper-
ature and driving conditions.
We recommend that you drive moderately until the pointer of the temper-
ature gauge reaches near the middle of the range. Engine operation is
optimum with the engine coolant at this temperature range and high rev-
ving operation when the engine is not warmed up enough should be
avoided.
Warning and indicator lights
Several of the warning and indicator lights come on momentarily and
then go out when the ignition switch is initially turned to the “ON” posi-
tion. This permits checking the operation of the bulbs.
Apply the parking brake and turn the ignition switch to the “ON” position.
The following lights come on:

Related Topics

Popular Owner Manuals