Get Instruments and controls -> Multi function display Guide for Subaru Outback SUV Fourth Generation (2010-2014)

indicated time will change in one-minute

decrements. If you keep the button

pressed, the rate at which the indicated

time changes will speed up.

Multi function display

Type A combination meter

1) Multi function display switching knob

Type B combination meter

1) Multi function display switching knob

With the ignition s witch in the “ ON”

position, each successive press of the

multi fun ction display switching knob

toggles the display in the following se-

quence.

The outside temperature is always indi-

cated on the display with the ignition

switch in the “ON” position.

Instruments and controls 3-33

– CONTINUED –

3-34 Instruments and controls

& Outside temperature indica-

tor

1) U.S. spec. models

2) Except U.S. spec. models

The outside temperature indicator shows

the outside temperature in a range from

−22 to 1228F (−30 to 508C).

The indicator can give a false reading

under any of the following conditions:

. When there is too much sun.

. During idling; while running at low

speeds in a traffic jam; when the engine

is restarted immediately following a shut-

down.

. When the actual outside temperature

falls outside the specified indicator range.

! Road surface freeze warning indi-

cation

1) U.S. spec. models

2) Except U.S. spec. models

When the outside temperature drops to

378F (38C) or lower, the temperature

indication flashes to show that the road

surface may be frozen.

If the outside temperature drops to 378F

(38C) or lower while the display is giving

an indication other than the outside

temperature, the display switches to the

outside temperature indication and flashes

for 5 seconds before returning to its

original indication.

If the display is already indicati ng an

outside temperature of 378F (38C) or lower

when the ignition switch is turned to the

“ON” position, the indication does not

flash.

NOTE

T he outs ide temperature indication

may differ from the actual outside

temperature. The road surface freeze

warning indication should be treated

only as a guide. Be sure to check the

condition of the road surface before

driving.

& Average fuel consumption

1) U.S. spec. models

2) Except U.S. spec. models

This indication shows the average rate of

fuel consumption since the trip meter was

last reset.

Pressing the trip knob toggles the indica-

tion between the average fuel consump-

tion corresponding to the A trip meter

indication and the average fuel consump-

tion corresponding to the B trip meter

indication.

When either of the trip meter indications is

reset, the corresponding av erage fuel

consumption value is also reset.

NOTE

. The indicated values vary in accor-

dance with changes in the vehicle’s

running conditions. Also, the indicated

values may differ slightly from the

actual val ues and should thus be

treated only as a guide.

. When either trip meter indication is

reset, the average fuel consumption

corresponding to that trip meter indica-

tion is not shown until the vehicle has

subsequently covered a distance of 1

mile (or 1 km).

& Current fuel consumption

1) U.S. spec. models

2) Except U.S. spec. models

This indication shows the rate of fuel

consumption at the present moment.

& Driving range on remaining

fuel

1) U.S. spec. models

2) Except U.S. spec. models

The driving range indicates the distance

that can be driven taking into account the

amount of fuel remaining in the tank and

the average rate of fuel consumption.

When the low fuel warning light illumi-

nates, the driving range indication flashes

for 5 seconds. (The display first switches

to the driving range indication if it was

originally giving some other indication.)

Instruments and controls 3-35

– CONTINUED –

3-36 Instruments and controls

1) U.S. spec. models

2) Except U.S. spec. models

If the driving range is shown as “

”,

there is only a tiny amount of fuel left in the

tank. You must refuel the vehicle immedi-

ately.

NOTE

The driving range on remaining fuel is

only a guide. The indicated value may

differ from the actual driving range on

remaining fuel, so you must immedi-

ately fill the tank when the low fuel

warning light illuminates.

Multi information display

(models with type A combi-

nation meter)

WARNING

Always pay adequate attention to

safe driving when operating the

multi information display while the

vehicle is in motion. When operation

of the multi information d isplay

interferes with your ability to con-

centrate on driving, stop the vehicle

before performing operations on the

screen. Also, do not concentrate on

the display while driving. Doing so

may cause you to look away from

the r oad and could result in an

accident.

Various information will be shown on the

multi information display. Also, a warning

message will appear on the display if a

malfunction, etc. is detected. In addition,

several settings for the displayed content

can be performed.

Multi information display

1) ECO gauge (refer to “ECO gauge” F3-

11.)

2) Warning screen (refer to “Warning

screen” F3-38.)/Basic screen (refer to

“Basic screens” F3-38.)

3) Select lever/gear position indicator (refer

to “Select lever/gear position indicator”

Instruments and controls -> Multi function display for Your Subaru Outback SUV Fourth Generation (2010-2014)

Related Topics

Popular Owner Manuals

Latest Owner Manuals