Get Inspection and Maintenance -> Fuses Guide for Suzuki Alto 4 Door Sixth Generation (2004-2008)

112

76G-74E

INSPECTION AND MAINTENANCE

9-29

To avoid harm to yourself or damage

to your vehicle or battery, follow the

jump starting instructions in the

EMERGENCY SERVICE section of this

manual if it is necessary to jump start

your vehicle.

The level of the battery solution must be

kept between the “MAX” and the “MIN” level

lines at all times. If the level is found to be

below the “MIN” level line, add distilled

water to the “MAX” level line. You should

periodically check the battery, battery

terminals, and battery hold-down bracket for

corrosion. Remove corrosion using a stiff

brush and ammonia mixed with water, or

baking soda mixed with water. After

removing corrosion, rinse with clean water.

If your vehicle is not going to be driven for

a month or longer, disconnect the cable from

the negative terminal of the battery to help

prevent discharge.

w WARNING

FUSES

1. Main fuse

2. Primary fuse (IG)

3. Primary fuse (Not under ignition switch)

4. Empty

5. Empty

6. Headlight (R)

7. Headlight (L)

8. Empty

9. Radiator fan motor fuse

0. Fuel injection system fuse

c. Air conditioner (If equipped)

76G-09-039

1. Main fuse

2. Primary fuse (IG)

3. Primary fuse (Not under ignition switch)

4. Empty

5. Empty

6. Headlight (R)

7. Headlight (L)

8. Blower

9. Radiator fan motor fuse

0. Fuel injection system fuse

c. Air conditioner (If equipped)

76G-09-039

ALTO

ALTO K10

113

76G-74E

INSPECTION AND MAINTENANCE

9-30

This vehicle has three types of fuses, as

described below :

Main Fuse - The main fuse takes current

directly from the battery.

Primary Fuses - These fuses are between

the main fuse and individual fuses, and are

for electrical load groups.

Individual Fuses - These fuses are in the

fuse box and for individual electrical circuits.

76G-09-040

EXAMPLE

1. HEATER 10A

2. WIPER/WASHER 15A

3. BLANK

4. STOP 10A

5. TAIL 10A

6. RADIO/DOME 15A

7. HORN HAZARD 15A

8. BLOWER 25A

9. IG 15A

0. TURN/BACK 10A

c. STEERING 30A

d. CIGAR 15A

e. STARTER FUSE 30A

f. FUSE PULLER

Main Fuse and Primary Fuses

The main fuse and primary fuses are

located in the engine compartment. If the

main fuse blows, no electrical component

will function. If a primary fuse blows, no

electrical component in the corresponding

load group will function. When replacing the

main fuse or a primary fuse, use a MARUTI

genuine replacement.

If the main fuse or a primary fuse

blows, be sure to have your vehicle

inspected by an authorized MARUTI

SUZUKI dealer. Always use a MARUTI

genuine replacement. Never use a

substitute such as a wire even for a

temporary repair, or extensive

electrical damage and a fire can result.

w WARNING

MAIN FUSE / PRIMARY FUSES

80A All Electric Load

60A

CIGAR, TURN/BACK, I.G./METER,

(IG)

HEATER, REAR DEFG, WIPER/

WASHER, POWER WINDOW

60A

DOOR LOCK, TAIL, STOP, RADIO/

DOME, HORN/HAZARD

76G-09-041

ALTO

114

76G-74E

9-31

INSPECTION AND MAINTENANCE

1. HEATER 10A

2. WIPER/WASHER 15A

3. DOOR LOCK 20A

4. STOP 10A

5. TAIL 10A

6. RADIO/DOME 15A

7. HORN HAZARD 15A

8. POWER STEERING 30A

9. IG 15A

0. TURN/BACK 10A

c. METER 10A

d. ACC 15A

e. CIGAR 15A

f. STARTER FUSE 30A

g. FUSE PULLER

h. POWER WINDOW 30A

76G-09-041A

ALTO K10

Fuse Box

The fuse boxes are located in the engine

compartment and under the driver’s side of

the dashboard.

To remove the fuse box cover under the

dashboard pull off the cover.

NOTE:

Alto

To remove the fuse from the fuse box use

the fuse puller given in the fuse box (under

dashboard) as shown in the illustration.

76G-09-042

ALTO

Fuse Box (under dashboard)

76G-09-042A

ALTO K10

Fuse Box (under dashboard)

NOTE:

Alto K10

Replace the fuse as described on the fuse

box cover. Use the fuse puller given in the

fuse box and keeping cover rib (1) in

downward direction as shown.

115

76G-74E

INSPECTION AND MAINTENANCE

9-32

Always be sure to replace a blown

fuse with a fuse of the correct

amperage. Never use a substitute

such as aluminium foil or wire to

replace a blown fuse. If you replace

a fuse and the new one blows in a

short period of time, you may have a

major electrical problem. Have your

vehicle inspected immediately by your

MARUTI SUZUKI dealer.

NOTE:

Make sure that the fuse box always carries

spare fuses.

w WARNING

76G-09-043

BULB REPLACEMENT

• Light bulbs can be hot enough to

burn your finger right after being

turned off. This is true especially for

halogen headlight bulbs. Replace the

bulbs after they become cool

enough.

• The headlight bulbs are filled with

pressurized halogen gas. They can

burst and injure you if they are hit

or dropped. Handle them carefully.

The oils from your skin may cause a

halogen bulb to overheat and burst

when the lights are on. Grasp a new

bulb with a clean cloth.

Frequent replacement of a bulb

indicates the need for an inspection of

the electrical system. This should be

carried out by your MARUTI SUZUKI

dealer.

CAUTION

w WARNING

76G-09-044

76G-09-045

Inspection and Maintenance -> Fuses for Your Suzuki Alto 4 Door Sixth Generation (2004-2008)

Related Topics

Popular Owner Manuals

Latest Owner Manuals