2004-2009 Suzuki Swift 4 Door OPERATING YOUR VEHICLE -> Parking brake lever User Manual
MyCarUserManual.com
USER MANUALS FOR EVERY MAKE & MODEL

OPERATING YOUR VEHICLE -> Parking brake lever for Your Suzuki Swift 4 Door First generation (2004-2009)

OPERATING YOUR VEHICLE  
by pressing the engine switch and then  
perform the engine starting operation.  
Refer to “Starting engine (vehicle with key-  
less push start system) (if equipped)” in  
this section.  
• Always keep the remote controller with  
you as the driver.  
NOTE:  
Parking brake lever  
• Even when the remote controller is in the  
interior workable area, if it is in any of the  
following conditions, you may not be  
able to start the engine or select the igni-  
tion modes, and the REMOTE CON-  
TROLLER OUTSIDE warning may be  
given.  
EXAMPLE  
(1)  
–The remote controller’s battery is low.  
–The remote controller is affected by  
strong radio wave or noise.  
–The remote controller is in contact with  
or covered by a metallic object.  
–The remote controller is in the secluded  
stowages such as the glove box or a  
door pocket.  
(2)  
(3)  
Interior workable area for keyless  
push start system  
–The remote controller is in the sun visor  
pocket or on the floor.  
54G039  
• Even when the remote controller is out-  
side the interior workable area, if it is in  
any of the following conditions, you may  
be able to start the engine or select the  
ignition mode. The REMOTE CON-  
TROLLER OUTSIDE warning may not  
be given at that time.  
–The remote controller is outside the  
vehicle but very close to a door.  
–The remote controller is in certain area  
on the instrument panel or in the lug-  
gage compartment.  
(1) To set  
(2) To release  
(3) To release  
(1)  
The parking brake lever is located between  
the front seats. To set the parking brake,  
depress the brake pedal and pull the park-  
ing brake lever all the way up. To release  
the parking brake, depress the brake pedal  
and pull up slightly on the parking brake  
lever, push the button on the end of the  
lever with your thumb, and lower the lever  
to its original position.  
68PH00306  
(1) Interior workable area  
The interior workable area is defined as all  
the interior spaces except for the space  
above the instrument panel or in the lug-  
gage compartment.  
3-10  
52RM0-01E  
OPERATING YOUR VEHICLE  
For automatic transaxle or CVT vehicles,  
always set the parking brake before mov-  
ing the gearshift lever to “P” (PARK) posi-  
tion. If you park on an incline and shift into  
“P” before setting the parking brake, the  
weight of the vehicle may make it difficult  
to shift out of “P” when you are ready to  
drive the vehicle.  
Parking brake reminder buzzer  
WARNING  
A buzzer sounds intermittently to remind  
you to release the parking brake if you  
start the vehicle without fully releasing the  
parking brake. Check that the parking  
brake is fully released and the brake sys-  
tem warning light turns off.  
Always set the parking brake fully  
before leaving your vehicle or it may  
move, causing injury or damage.  
When parking, make sure the gear-  
shift lever for manual transaxle vehi-  
cles is in 1st gear or “R” (Reverse)  
and the gearshift lever for automatic  
transaxle or CVT vehicles is in “P”  
(Park). Remember, even though the  
transaxle is in gear or in Park, you  
must set the parking brake fully.  
When preparing to drive the vehicle, move  
the gearshift lever out of “P” position  
before releasing the parking brake.  
WARNING  
• Never drive your vehicle with the  
parking brake on: rear brake effec-  
tiveness can be reduced from over-  
heating, brake life may be  
shortened, or permanent brake  
damage may result.  
• If the parking brake does not hold  
the vehicle securely or does not  
fully release, have your vehicle  
inspected immediately by an autho-  
rized SUZUKI dealer.  
WARNING  
When parking the vehicle in  
extremely cold weather, the following  
procedure should be used:  
1) Set the parking brake.  
2) Manual transaxle – turn off the  
engine, then shift into reverse or  
first gear.  
Automatic transaxle or CVT – shift  
into “P” (Park) and turn off the  
engine.  
3) Get out of the vehicle and put  
chocks under the wheels.  
4) Release the parking brake.  
When you return to your vehicle,  
first set the parking brake, and  
then remove the wheel chocks.  
3-11  
52RM0-01E  

Related Topics

Popular Owner Manuals