Incaseofanemergency -> If you cannot shift selector lever for Your Toyota 4 Runner SUV Third Generation (1996-2002)

’01 4Runner_U (L/O 0008)  
If you cannot shift automatic  
transmission selector lever  
(two−wheel drive models)  
—Tips for towing a stuck  
vehicle  
The following methods are effective to  
get out when your vehicle is struck in  
mud, sand or other condition from  
which the vehicle cannot be driven out  
under its own power. Use extreme cau-  
tion when towing vehicles. In addition,  
keep away from the vehicles and towing  
cable or chain when towing.  
CAUTION  
If the emergency towing hook is used  
to get out when your vehicle becomes  
struck in mud, sand or other condi-  
tion from which the vehicle cannot be  
driven out under its own power, make  
sure to observe the precautions men-  
tioned below. Otherwise, excessive  
stress will be put on the hook and  
the towing cable or chain may break,  
causing serious injury or damage.  
D Remove the soil and sand in the front  
and the back of the tires.  
D Place a stone or wood under the tires.  
D If the towing vehicle can hardly  
move, do not forcibly continue the  
towing. Contact your Toyota dealer  
or a commercial tow truck service  
for assistance.  
If you cannot shift the selector lever  
out of “P” position to other positions  
even though the brake pedal is de-  
pressed, use the shift lock override but-  
ton as follows:  
D Tow the vehicle as straight ahead  
as possible.  
1. Turn the ignition key to “LOCK”  
position. Make sure the parking  
brake is set.  
D Keep away from the vehicle during  
towing.  
2. Pry up the cover with a flat−bladed  
screwdriver or equivalent.  
2001 4RUNNER (OM35768U)  
236  
’01 4Runner_U (L/O 0008)  
If you cannot shift automatic  
transmission selector lever  
(four−wheel drive models)  
3. Insert the screwdriver or equivalent  
into the hole to push down the shift  
lock override button. You can shift  
out of “P” position only while push-  
ing the button.  
If you cannot shift the selector lever  
out of “P” position to other positions  
even though the brake pedal is de-  
pressed, use the shift lock override but-  
ton as follows:  
3. Insert your finger into the hole to  
move the shift lock overdrive lever  
backward. You can shift out of “P”  
position only while holding back the  
lever.  
4. Shift into “N” position.  
5. Insert the cover.  
1. Turn the ignition key to “LOCK”  
position. Make sure the parking  
brake is set.  
4. Shift into “N” position.  
5. Insert the cover.  
6. Start the engine. For your safety,  
keep the brake pedal depressed.  
6. Start the engine. For your safety,  
keep the brake pedal depressed.  
2. Pry up the cover with a flat−bladed  
screwdriver or equivalent.  
Be sure to have the system checked by  
your Toyota dealer as soon as possible.  
Be sure to have the system checked by  
your Toyota dealer as soon as possible.  
2001 4RUNNER (OM35768U)  
237