AX–3
AUTOMATIC TRANSAXLE (A246E)
–
NEUTRAL START SWITCH
NEUTRAL START SWITCH
AX0PK–02
ON–VEHICLE REPAIR
1.
REMOVE LH ENGINE UNDER COVER
2.
3.
DISCONNECT SHIFT CABLE FROM CONTROL SHIFT
LEVER
DISCONNECT NEUTRAL START SWITCH CONNEC-
TOR
Q08545
4.
REMOVE NEUTRAL START SWITCH
(a) Remove the nut, washer and control shaft lever.
(b) Pry out the lock washer and remove the manual valve
shaft nut.
(c) Remove the 2 bolts and pull out the neutral start switch.
D08573
5.
INSTALL AND ADJUST NEUTRAL START SWITCH
(a) Install the neutral start switch with 2 bolts.
Torque: 5.4 N·m (55 kgf·cm, 48 in.·lbf)
(b) Install a new lock plate and tighten the nut.
Torque: 6.9 N·m (70 kgf·cm, 61 in.·lbf)
(c) Stake the nut with lock plate.
(d) Install the control shift lever, washer and nut.
Torque: 12 N·m (120 kgf·cm, 9 ft·lbf)
6.
7.
CONNECT NEUTRAL START SWITCH CONNECTOR
CONNECT SHIFT CABLE TO CONTROL SHIFT LEVER
Torque: 12 N·m (120 kgf·cm, 9 ft·lbf)
8.
CHECK NEUTRAL START SWITCH OPERATION
Check that the engine can be started with the shift lever only in
the N or P range, but not in other ranges.
If not as started above, carry out the adjustment procedure
(See page DI–3).
9.
INSTALL LH ENGINE UNDER COVER
10. TEST DRIVE VEHICLE
AVENSIS/CORONA SUP (RM781E)
English 