Get Instruments, indicators and service lights -> Oil maintenance management system Guide for Toyota Avensis 4 Door Second Generation (2004-2009)

Machine Translated by Google

INSTRUMENTS, INDICATORS AND SERVICE LIGHTS

154

Oil maintenance management system

(diesel engines, without combined display)

3. Instrument panel lighting control display

(when the headlight switch is on)

The Oil Maintenance Management System

(OMMS) is designed to inform you via a

warning light when it is time to change the

oil and oil filter.

ÿ Shows the brightness of the instrument panel

lighting. The higher the height of the column, the

brighter the illumination of the instrument panel.

4. Reset button for sub-kilometer counters/

instrument panel lighting control ÿ Resets

both sub-kilometer counters, changes the

display and adjusts the brightness of the

instrument panel lighting.

CHANGING ENGINE OIL AND OIL-

JOHN FILTER

Change the engine oil and oil filter in any of the

following cases:

• When the engine oil change light is on

To change the display view, quickly press and

release the button. Each time the button is pressed,

the display changes from the total counter to sub-

counter A, sub-counter B, the instrument panel

lighting control display and then back to the total

counter.

• When the system is being

repaired. • When the engine oil change light

does not illuminate even if 2 years have

passed since the oil change.

• When the engine oil change indicator light

does not illuminate even though it has been

more than 30000 km since the oil change.

To reset sub-counter A, switch to this counter

display and press and hold the button until

the counter reading is reset to zero. Use the

same procedure to reset counter B.

The lighting interval may vary according to

driving conditions.

To adjust the brightness of the instrument

panel illumination, switch to the instrument

panel illumination brightness setting view

and press and hold the button until the

desired brightness is reached.

Because the condition of the engine oil

deteriorates over time, there are times when

the engine oil must be changed before the

engine oil change light comes on. In these

cases, replace the engine oil and oil filter

according to the maintenance schedule

(Engine oil maintenance intervals - see

"Toyota Service Book" or "Toyota Warranty

Book".)

5. Reset button for sub-kilometer counters –

Resets both sub-kilometer counters,

changes the display.

To change the display view, quickly press and

release the button. Each time the button is pressed,

NOTICE

the display changes from the total counter to sub-

counter A, sub-counter B and then back to the total

counter.

Reset the system after changing the

engine oil and oil filter. (System reset

procedure - see "SYSTEM RESET" on page

155 in this chapter.)

To reset sub-counter A, switch to this counter

display and press and hold the button until

the counter reading is reset to zero. Use the

same procedure to reset counter B.

If you do not reset the system, it cannot

inform you of the correct time to change

the engine oil and oil filter.

Machine Translated by Google

INSTRUMENTS, INDICATORS AND SERVICE LIGHTS

155

If any of the following situations occur, the system

may not operate normally. Have the vehicle inspected

by any authorized Toyota dealer or workshop, or by

another properly qualified and equipped professional.

• When the ignition key is turned to the "ON" position, the

indicator light does not light up.

• The indicator light flashes.

• After changing the engine oil and oil filter,

even if the system has been reset, the

warning light does not go out or comes on soon

again.

ENGINE REPLACEMENT LIGHT

OILS

SYSTEM RESET

This light comes on when you turn the ignition key to the

"ON" position. It turns off after about 5 seconds. This

means that the system is working normally.

The system must be reset after changing the engine oil.

Perform a system reset as follows:

If this light comes on while driving, replace the engine

1. Turn the ignition key to the "ACC" or "LOCK" position

with the odometer displayed. (Details - see "Total and

two trip meter display and instrument panel lighting

control" on page 153 in this chapter.)

oil and oil filter at the earliest opportunity using the

appropriate replacement parts. For more information

on oil grade and viscosity - see "Checking the engine

oil level" on page 372 in chapter 7ÿ2.

After changing the engine oil and oil filter, reset the

system with the engine oil change light reset switch so

that the light goes out. The system must also be reset if

the engine oil and oil filter are changed before the

warning light comes on. If you do not reset the system, it

cannot inform you of the correct time to change the

engine oil.

2. Turn the ignition key to the "ON" position while keeping

the odometer reset button pressed.

Hold the button for at least 5 seconds. The total odometer

will display "000000" and the control will go out.

If the reset system fails, the light will continue to flash.

Machine Translated by Google

INSTRUMENTS, INDICATORS AND SERVICE LIGHTS

156

Oil maintenance management system

(diesel engines, with combined

display)

The Oil Maintenance Management System

(OMMS) is designed to inform you

through reports when the oil and oil filter

need to be changed.

CHANGING ENGINE OIL AND OIL-

JOHN FILTER

Change the engine oil and oil filter in any of

the following cases:

• When the engine oil change warning message

appears, the main warning light will illuminate

and a warning tone will sound.

MOTOR REPLACEMENT WARNING MESSAGE

MY OIL

• When the system is being

This message appears when you turn the ignition

key to the "ON" position. After about 5 seconds,

the message disappears. This means that the

repaired. • When the engine oil change

warning message does not appear

even if 2 years have passed since the oil change.

system is working normally.

• When the engine oil change warning

message does not appear even though

it has been more than 30,000 km since

the oil change.

If this message appears while driving, replace the

engine oil and oil filter at the earliest opportunity

using the appropriate replacement parts. For

more information on oil grade and viscosity - see

The lighting interval may vary according to

driving conditions.

"Checking the engine oil level" on page 372 in

chapter 7ÿ2.

Because the condition of the engine oil

deteriorates over time, there are times

when it is necessary to change the engine

oil before the engine oil change warning

message appears. In these cases, replace

the engine oil and oil filter according to

the maintenance schedule (Engine oil

maintenance intervals - see "Toyota

After changing the engine oil and oil filter,

reset the system with the engine oil change

warning message reset switch so that the

message disappears. The system must also

be reset if the engine oil and oil filter are

changed before the message appears. If you

do not reset the system, it cannot inform you

of the correct time to change the engine oil.

Service Book" or "Toyota Warranty Book".)

NOTICE

Reset the system after changing the

engine oil and oil filter. (System reset

procedure - see "SYSTEM RESET" on

page 157 in this chapter.)

If you do not reset the system, it cannot

inform you of the correct time to change

the engine oil and oil filter.

Machine Translated by Google

157

INSTRUMENTS, INDICATORS AND SERVICE LIGHTS

Combined Display –

If any of the following situations occur,

the system may not operate normally.

Have the vehicle inspected by any

authorized Toyota dealer or workshop, or

by another properly qualified and equipped

professional. • When the ignition key is

turned to the "ON" position, the message

does not appear.

• After changing the engine oil and oil filter, even

if the system has been reset, the message

does not disappear or reappears soon.

SYSTEM RESET

The system must be reset after changing

the engine oil. Perform a system reset as

follows:

1. Turn the ignition key to the "ACC" or

"LOCK" position with the odometer

displayed. (Details - see "Total and two

trip meter display and instrument panel

lighting control" on page 153 in this

chapter.)

2. Turn the ignition key to the "ON" position while

keeping the odometer reset button pressed.

Hold the button for at least 5 seconds. The odometer

will display "000000" and the message will disappear.

1. Ride information

2. Hours

3. Outside temperature

4. "DISP." button.

Instruments, indicators and service lights -> Oil maintenance management system for Your Toyota Avensis 4 Door Second Generation (2004-2009)

Related Topics

Instruments, indicators and service lights

Popular Owner Manuals

Latest Owner Manuals