OPERATION OF INSTRUMENTS AND CONTROLS - Keys and Doors -> Side doors for Your Toyota Prius 4 Door First Generation (1997-2003)

Side doors—  
The driver’s window can be opened and  
closed from outside the vehicle using a  
key. For details, see “Power windows” on  
page 28 in this section.  
LOCKING AND UNLOCKING WITH KEY  
LOCKING AND UNLOCKING WITH IN-  
SIDE LOCK KNOB  
Insert the key into the keyhole and turn  
it.  
Move the lock knob.  
To lock: Turn the key forward.  
To unlock: Turn the key backward.  
To lock: Push the knob forward.  
To unlock: Pull the knob backward.  
All the doors lock and unlock simulta-  
neously with either front door. In the driv-  
er’s door lock, turning the key once will  
unlock the driver’s door and twice in suc-  
cession will unlock all the doors simulta-  
neously.  
The driver’s door can be opened by pull-  
ing the inside door handle even if the lock  
knob is depressed.  
Closing the door with the lock knob in the  
lock position will also lock the door. Be  
careful not to lock your keys in the ve-  
hicle.  
The door cannot be locked if you leave  
the key in the ignition switch.  
22  
LOCKING AND UNLOCKING WITH  
POWER DOOR LOCK SWITCH  
Push the switch.  
To lock: Push the switch on the front side.  
To unlock: Push the switch on the rear  
side.  
All the doors lock or unlock simultaneous-  
ly.  
Driver’s side  
REAR DOOR CHILD−PROTECTORS  
Move the lock lever to the “LOCK”  
position as shown on the label.  
This feature allows you to lock a rear  
door so it can be opened from the outside  
only, not from inside. We recommend us-  
ing this feature whenever small children  
are in the vehicle.  
Passenger’s side  
23  
—Wireless remote control  
The wireless remote control system is  
designed to lock or unlock both doors,  
or activate the theft deterrent system  
from a distance within approximately 1  
m (3 ft.) of the vehicle.  
CAUTION  
Before driving, be sure that the doors  
are closed and locked, especially  
when small children are in the ve-  
hicle. Along with the proper use of  
seat belts, locking the doors helps  
prevent the driver and passengers  
from being thrown out from the ve-  
hicle during an accident. It also helps  
prevent the doors from being opened  
unintentionally.  
LOCKING  
DOORS  
AND  
UNLOCKING  
THE  
To lock and unlock all the doors, push  
the switches of the transmitter slowly  
and securely.  
To lock: Push the “LOCK” switch. All the  
doors are locked simultaneously. At this  
time the parking lights, side marker lights,  
license plate lights and tail lights will flash  
once.  
Locking operation  
Check to see that the doors are securely  
locked.  
If either door is not securely closed, lock-  
ing cannot be performed by the “LOCK”  
switch.  
Unlocking operation  
24  
To unlock: Push the “UNLOCK” switch  
once to unlock the only driver’s door.  
Pushing the switch twice within 3 seconds  
unlocks all the doors simultaneously. Each  
time the “UNLOCK” switch is pushed, the  
parking lights, side marker lights, license  
plate lights and tail lights will flash twice.  
WIRELESS REMOTE CONTROL TRANS-  
MITTER  
The wireless remote control transmitter is  
an electronic component. Observe the fol-  
lowing instructions in order not to cause  
damage to the transmitter.  
D Do not leave the transmitter on places  
where the temperature becomes high  
such as on the dashboard.  
When the “UNLOCK” switch is pressed  
the interior light comes on. The lights re-  
mains on for about 15 seconds unless  
either door is opened then and closed.  
(For further information, see “Interior  
lights” on page 84 in Section 23.)  
D Do not disassemble it.  
D Avoid knocking it hard against other  
objects or dropping it.  
PANIC” SWITCH  
You have 30 seconds to open a door after  
using the wireless remote unlock feature.  
If a door is not opened by then, all the  
doors will be automatically locked again.  
D Avoid putting it in water.  
Pushing the “PANIC” switch blows the  
horn intermittently and flashes the  
headlights and tail lights.  
You can use up to 4 wireless remote con-  
trol transmitters for the same vehicle.  
Contact your Toyota dealer for detailed  
information.  
If the “LOCK” or “UNLOCK” switch is kept  
pressed in, the locking or unlocking opera-  
tion is not repeated. Release the button  
and then push again.  
The “PANIC” switch is used to deter ve-  
hicle theft when you witness anyone at-  
tempting to break into or damage your  
vehicle.  
If the wireless remote control transmitter  
does not actuate the doors or alarm, or  
operate from a normal distance.  
The alarm will have for one minute. To  
stop alarm midway, push the “PANIC” or  
“UNLOCK” switch once again, unlock any  
door with the key or transmitter, or turn  
the ignition key from the “LOCK” to “ON”  
position.  
D Check for closeness to a radio trans-  
mitter such as a radio station or an  
airport which can interfere with normal  
operation of the transmitter.  
D The batteries may have been con-  
sumed. Check the battery in the trans-  
mitter. To replace the battery, see “RE-  
PLACING TRANSMITTER BATTERY”  
below.  
The “PANIC” mode does not work when  
the ignition key is in the “ON” position.  
25  
If you lose your transmitter, contact your  
Toyota dealer as soon as possible to  
avoid the possibility of theft, or an acci-  
dent. (See “If you lose your wireless re-  
mote control transmitter” on page 183 in  
Section 5.)  
NOTICE:  
D Reorient or relocate the receiving an-  
tenna.  
This equipment has been tested and  
found to comply with the limits for a  
Class B digital device, pursuant to Part  
15 of the FCC Rules. These limits are  
designed to provide reasonable protec-  
D Increase the separation between the  
equipment and receiver.  
D Connect the equipment into an outlet  
For vehicles sold in U.S.A.  
on  
a
circuit different from that to  
tion against harmful interference in  
a
which the receiver is connected.  
residential installation. This equipment  
generates, uses and can radiate radio  
frequency energy and, if not installed  
and used in accordance with the instruc-  
tions, may cause harmful interference to  
radio communications. However, there is  
no guarantee that interference will not  
occur in a particular installation. If this  
equipment does cause harmful interfer-  
ence to radio or television reception,  
which can be determined by turning the  
equipment off and on, the user is en-  
couraged to try to correct the interfer-  
ence by one or more of the following  
measures:  
This device complies with Part 15 of the  
FCC Rules. Operation is subject to the  
following two conditions:  
D Consult the dealer or an experienced  
radio/TV technician for help.  
FCC WARNING:  
(1) This device may not cause harmful  
interference, and (2) this device must  
accept any interference received, includ-  
ing interference that may cause unde-  
sired operation.  
Changes or modifications not ex-  
pressly approved by the party respon-  
sible for compliance could void the  
user’s authority to operate the equip-  
ment.  
For vehicles sold in Canada  
Operation is subject to the following two  
conditions: (1) this device may not  
cause interference, and (2) this device  
must accept any interference, including  
interference that may cause undesired  
operation of this device.  
26  
REPLACING TRANSMITTER BATTERY  
For replacement, use CR2016 lithium bat-  
tery or equivalent.  
CAUTION  
Special care should be taken that  
small children do not swallow the re-  
moved transmitter battery or compo-  
nents.  
NOTICE  
z During replacing the transmitter  
battery, do not push the “LOCK”  
1. Using a coin or equivalent, open the  
transmitter case.  
2. Remove the discharged transmitter bat-  
tery.  
and  
times.  
“UNLOCK”  
switches many  
NOTICE  
z When replacing the transmitter bat-  
tery, be careful not to lose the  
components.  
Do not bend the terminals.  
z Replace only with the same or  
equivalent type recommended by a  
Toyota dealer.  
z Dispose of used batteries according  
to the local laws.  
Replace the transmitter battery by the fol-  
lowing procedures.  
27