2008-2017 Vauxhall Insignia 4 Door Vehicle care -> Vehicle checks User Manual
MyCarUserManual.com
USER MANUALS FOR EVERY MAKE & MODEL

Vehicle care -> Vehicle checks for Your Vauxhall Insignia 4 Door First Generation (2008-2017)

Vehicle care  
217  
■ Open bonnet, close all doors and  
lock the vehicle.  
■ Disconnect the clamp from the  
negative terminal of the vehicle  
battery. Beware that all systems are  
not functional, e.g. anti-theft alarm  
system.  
website, where legally required. Only  
entrust this work to an authorised  
recycling centre.  
Gas vehicles must be recycled by a  
service centre authorised for gas  
vehicles.  
Vehicle checks  
Performing work  
Putting back into operation  
When the vehicle is to be put back into  
operation:  
■ Connect the clamp to the negative  
terminal of the vehicle battery.  
Activate the electronics of the  
power windows.  
■ Check tyre pressure.  
■ Fill up the washer fluid reservoir.  
■ Check the engine oil level.  
■ Check the coolant level.  
9 Warning  
Only perform engine compartment  
checks when the ignition is off.  
The cooling fan may start  
operating even if the ignition is off.  
■ Fit the number plate if necessary.  
End-of-life vehicle  
recovery  
Information on end-of-life vehicle  
recovery centres and the recycling of  
end-of-life vehicles is available on our  
218  
Vehicle care  
Engine oil  
9 Danger  
Check the engine oil manually on a  
regular basis to prevent damage to  
the engine. Ensure that the correct  
specification of oil is used.  
The ignition system and Xenon  
headlights use extremely high  
voltage. Do not touch.  
Recommended fluids and lubricants  
3 266.  
Bonnet  
Opening  
Check with the vehicle on a level  
surface. The engine must be at  
operating temperature and switched  
off for at least 5 minutes.  
Pull out the dipstick, wipe it clean,  
insert it to the stop on the handle, pull  
out and read the engine oil level.  
Insert dipstick to the stop on the  
handle and make half a turn.  
Move the safety catch sideways to the  
left vehicle side and open the bonnet.  
The bonnet is held open  
automatically.  
Air intake 3 150.  
If the bonnet is opened during an  
Autostop, the engine will be restarted  
automatically for safety reasons.  
Stop-start system 3 157.  
Pull the release lever and return it to  
its original position.  
Closing  
Lower the bonnet and allow it to drop  
into the catch. Check that the bonnet  
is engaged.  
Vehicle care  
219  
When the engine oil level has  
dropped to the MIN mark, top up  
engine oil.  
Different dipsticks are used  
depending on engine variant.  
The engine oil level must not exceed  
the MAX mark on the dipstick.  
Caution  
We recommend the use of the same  
grade of engine oil that was used at  
last change.  
Overfilled engine oil must be  
drained or suctioned out.  
Capacities 3 286, Engine oil quality/  
viscosity 3 266.  
Fit the cap on straight and tighten it.  
220  
Vehicle care  
Automatic transmission fluid level  
normally does not have to be  
checked. To check the fluid level seek  
the assistance of a workshop.  
Automatic transmission  
fluid  
Caution  
Engine coolant  
Extremely small amounts of  
contamination can cause  
automatic transmission damage  
and cause it to not work properly.  
Do not allow contaminates to  
contact the fluid side of the  
reservoir cap or from entering the  
reservoir.  
The coolant provides freeze  
protection down to approx. -28 °C. In  
northern countries with very low  
temperatures the factory filled coolant  
provides frost protection down to  
approx. -37 °C.  
If the cooling system is cold, the  
coolant level should be above the  
filling line mark. Top up if the level is  
low.  
Caution  
Only use approved antifreeze.  
Coolant level  
Caution  
Too low a coolant level can cause  
engine damage.  
Vehicle care  
221  
On another version the filling line  
mark is inside the filler opening. To  
check open the cap.  
General  
contaminates to contact the fluid  
side of the reservoir cap/dipstick or  
from entering the reservoir.  
9 Warning  
Additional cooling circuit for Turbo  
engine  
Coolant container is fixed at the air  
cleaner housing.  
Allow the engine to cool before  
opening the cap. Carefully open  
the cap, relieving the pressure  
slowly.  
To top up use a 1:1 mixture of  
released coolant concentrate mixed  
with clean tap water. If no coolant  
concentrate is available, use clean  
tap water. Install the cap tightly. Have  
the coolant concentration checked  
and have the cause of the coolant  
loss remedied by a workshop.  
Power steering fluid level normally  
does not have to be checked. If an  
unusual noise sounds during steering  
or the power steering reacts  
conspicuous seek the assistance of a  
workshop.  
Power steering fluid  
If the cooling system is cold, the  
coolant level should be above the  
filling line mark. Top up if the level is  
low.  
Caution  
Extremely small amounts of  
contamination can cause steering  
system damage and cause it to not  
work properly. Do not allow  
222  
Vehicle care  
Washer fluid  
Brakes  
In the event of minimum thickness of  
the brake lining, a squealing noise  
sounds during braking.  
Continued driving is possible but  
have the brake lining replaced as  
soon as possible.  
Once new brake linings are installed,  
do not brake unnecessarily hard for  
the first few journeys.  
Brake fluid  
The brake fluid level must be between  
the MIN and the MAX marks.  
Fill with clean water mixed with a  
suitable quantity of windscreen  
washer fluid which contains  
antifreeze.  
9 Warning  
If fluid level is below MIN seek the  
assistance of a workshop.  
Brake fluid is poisonous and  
corrosive. Avoid contact with eyes,  
skin, fabrics and painted surfaces.  
Brake and clutch fluid 3 266.  
Caution  
Vehicle battery  
Vehicles without stop-start system  
will be equipped with a lead acid  
battery. Vehicles with stop-start  
system will be equipped with an AGM  
battery which is not a lead acid  
battery.  
Only washer fluid with a sufficient  
antifreeze concentration provides  
protection at low temperatures or  
a sudden drop in temperature.  
Vehicle care  
223  
The vehicle battery is maintenance-  
free provided that the driving profile  
allows sufficient charging of the  
battery. Short-distance-driving and  
frequent engine starts can discharge  
the battery. Avoid the use of  
off with a dummy cap, and the  
ventilation in the vicinity of the  
Replacing the vehicle battery  
Note  
Any deviation from the instructions  
given in this paragraph may lead to  
a temporary deactivation of the stop-  
start system.  
negative terminal must be opened.  
Only use vehicle batteries that allow  
the fuse box to be mounted above the  
battery.  
In vehicles with stop-start system, be  
sure to have the AGM (Absorptive  
Glass Mat) battery replaced with an  
AGM battery again.  
unnecessary electrical consumers.  
Batteries do not belong in household  
waste. They must be disposed of at  
an appropriate recycling collection  
point.  
Laying up the vehicle for more than  
4 weeks can lead to vehicle battery  
discharge. Disconnect the clamp from  
the negative terminal of the vehicle  
battery.  
The vehicle battery is covered.  
Remove the cover to replace the  
battery. Lift up the cover at the rear  
and unlatch it at the front.  
Ensure the ignition is switched off  
before connecting or disconnecting  
the vehicle battery.  
An AGM battery can be identified by  
the label on the battery. We  
recommend the use of an original  
Opel battery.  
When the battery is being replaced,  
please ensure that there are no open  
ventilation holes in the vicinity of the  
positive terminal. If a ventilation hole  
is open in this area, it must be closed  
Battery discharge protection 3 136.  
224  
Vehicle care  
Note  
■ See the Owner’s Manual for further  
information.  
■ Explosive gas may be present in  
the vicinity of the vehicle battery.  
Warning label  
Using an AGM battery different from  
the original Opel battery might result  
in a lower performance of the stop-  
start system.  
We recommend that you have the  
vehicle battery replaced by a  
workshop.  
Diesel fuel system  
bleeding  
If the tank has been run dry, the diesel  
fuel system must be bled. Switch on  
the ignition three times for  
Stop-start system 3 157.  
Charging the vehicle battery  
15 seconds at a time. Then crank the  
engine for a maximum of  
40 seconds. Repeat this process after  
no less than 5 seconds. If the engine  
fails to start, seek the assistance of a  
workshop.  
9 Warning  
Meaning of symbols:  
■ No sparks, naked flames or  
smoking.  
■ Always shield eyes. Explosive  
gases can cause blindness or  
injury.  
On vehicles with stop-start  
system, ensure that the charging  
potential does not exceed  
14.6 volts when using a battery  
charger. Otherwise the battery  
might be damaged.  
■ Keep the vehicle battery out of  
reach of children.  
Jump starting 3 256.  
■ The vehicle battery contains  
sulphuric acid which could cause  
blindness or serious burn injuries.  
Vehicle care  
225  
Wiper blade on the rear window  
Wiper blade replacement  
Wiper blades on the windscreen  
Disengage the wiper blade and  
remove.  
Attach the wiper blade slightly angled  
to the wiper arm and push until it  
engages.  
Lift the wiper arm. Press the two  
catches on the arm, disengage the  
wiper blade and remove.  
Attach the wiper blade slightly angled  
to the wiper arm and push until it  
engages.  
Lift the wiper arm and open the  
retaining clip.  
Lower wiper arm carefully.  
Lower wiper arm carefully.  

Related Topics

Popular Owner Manuals