When automatic mode is active, the car uses information from its rain sensor to activate the wipers and control their speed. You
can change the rain sensor sensitivity in settings and the quick controls view. When the rain sensor is active, you can see a
symbol in the display.
Active rain sensor symbol
Rear wiper
Use the left-hand steering wheel stalk to manually turn the rear wiper on or off. The driver information area of the display shows
whether the rear wiper is active or not.
You can also enable a setting to allow the rear wiper to activate automatically when you are reversing the car. When this setting
is enabled via the display, the rear wiper automatically activates if the front windscreen wipers are active while you are reversing.
If you change gear, the rear wiper will stop wiping the rear windscreen.
Important
Maintenance, refilling and replacing
Clean the wiper blades regularly.
Replace the wiper blades if they show signs of wear.
Refill washer fluid when your car tells you to.
Avoid using the wipers without lubrication from either rain or washer fluid. It can cause wear or damage.
Car wash safety
Turn the automatic wiper mode off when you enter a car wash. Otherwise, the rain sensor will cause the wipers to activ-
ate, which could lead to damage.
9.3.1. Controlling front wipers
The content of this manual represents the status of the user manual at the time of printing and may not be completely valid in future
instances. For more information, refer to the first page for the complete disclaimer note.
214 / 396
English 
