9.1.1.2. High beam
The high beam is important for your driving visibility. There are different states you can use to suit your
needs.
Important
Remember that your ability to see the road properly in low lighting conditions is important not just for your own safety,
but for other road users and pedestrians too.
The high beam is more powerful and has a longer reach of illumination than the passing beam. To use the high beam, you must
first activate the automatic lights mode or passing beam.
When the automatic high beam is active, the car automatically reacts to oncoming traffic to avoid dazzling other road users.
Note
The automatic high beam only activates at speeds over approximately 40 km/h (25 mph) and in low light.
Use the left-hand steering wheel stalk to switch between the different high beam settings. There are symbols in the display that
show which high beam setting is currently active. These include:
The manual high beam is active.
The automatic high beam is enabled.
The automatic high beam is active.
Important
Make sure that the car cameras are well-maintained and kept clean. If the cameras’ views are obscured by dirt, they will
not be able to obtain enough information to properly direct the car’s lighting responses.
9.1.1.3. Passing beam
The passing beam reduces the risk of dazzling other road users.
The passing beam is part of the automatic lights mode. However, you can manually select the passing beam in the display.
9.1.1.3.1. Activating the passing beam
The content of this manual represents the status of the user manual at the time of printing and may not be completely valid in future
instances. For more information, refer to the first page for the complete disclaimer note.
205 / 396
English 
