To securely install a child restraint on the front passenger seat, there is important information to read and
recommendations to follow.
Top tether, lower tether as well as ISOFIX anchorage points[1] can be used when installing a child restraint on the front passen-
ger seat.
Tip
Long-term use of a child restraint may cause wear and tear on the car interior. Use a kick guard accessory to protect the
car interior.
Allowed child restraints
Only use child restraints that are recommended by Volvo, universally approved or are vehicle specific approved where the
car is included in the manufacturer’s vehicle list.
Seat preparations
Retract the seat cushion extension and remove cushion extenders, leg supports and other accessories from the seat before
installing a child restraint. If you use a kick guard accessory, this can remain on the seat.
Any support legs of a child restraint should always be fitted directly to the floor. Do not fit support legs to any raised or
uneven floor surfaces, footrests or other objects. Adjust the seat position if needed.
Loose objects should not be stored around any support legs of a child restraint.
Any restraining straps of a child restraint should always be secured to designated anchorage points. Do not secure
restraining straps to seat rails, handles or other parts of the interior.
When installing a child restraint using the lower tether anchorage points, never adjust the seat position to tighten the
straps.
When installing rearward-facing child restraints, adjust the seat to its lowest position.
When installing adjustable, rearward-facing child restraints, adjust the child restraint according to the child’s age. Older
children should be seated in a more upright position than younger ones.
Seatbelt use
When installing a child restraint secured using the car's seatbelt or when the car's seatbelt is used to secure a child, ensure
that brackets or other parts of the restraint do not come into contact with the seatbelt buckle button.
When securing a child with the car's seatbelt, always start with the seatbelt's upper anchorage point adjusted to its highest
level. Then lower it as needed to properly position the belt against the shoulder.
The content of this manual represents the status of the user manual at the time of printing and may not be completely valid in future
instances. For more information, refer to the first page for the complete disclaimer note.
136 / 444