Information
–
Keep the sensors clear of snow, ice, and large
accumulations of dirt. If the sensors are covered, the
accuracy of the system may be adversely affected. Do
not clean the sensors with sharp objects.
–
If your vehicle has damage to the bumper or radiator
grille that causes the bumper or radiator grille to be
misaligned or bent, the detection range may be
altered, resulting in inaccurate measurement of
obstacles or false warnings.
–
Certain additional devices installed around the
bumper or trim can create false alarms. For example,
large ball couplings, bicycle or surfboard racks,
number plate holders, bumper covers, or other
devices that may block the system’s normal detection
zone. Remove the additional device to avoid false
alarms.
–
The parking aid warns the driver of obstacles that are
in a specific range of your vehicle. The system switches
on automatically when you turn on the ignition. The
system can be turned off using the following methods:
-
Via the information display menu
-
Via the pop-up notice that is displayed as soon as you
engage reverse gear (R)
-
Via the parking aid button (if present)
–
If there is a fault in the system, a driver message
appears in the information display. For more
information on correct operation of the parking aid,
refer to the operating manual for the vehicle.
If possible, parking aid senders should not be removed
from their original X, Y, and Z plane positions.
Maintaining the sensor position on these planes is
important for proper operation of the system.
–
Volkswagen Commercial Vehicles – Body builder guidelines – February 2023 edition
The new Amarok – Page 86 of 166