—Pull the lever underneath the seat upwards→ Fig. 1 (close-up) to release the seat.
—Lift the seat forward slightly to detach it from the locking mechanism on the floor.
—Reach into the recessed areas on the left and right sides of the seat and remove the seat.
Fitting the seat
—Insert the seat into the mounts in the floor.
—Press the seat into the mounts until it engages audibly. The seat is engaged securely if the red mark on the floor
1
locking mechanism → Fig. 2
is not visible →
.
—Fold back the backrest (→ Third seat row).
WARNING
Injuries could be caused if the seats are removed and installed carelessly.
● Never remove or install the seat while the vehicle is in motion.
● Always keep hands, fingers, feet or other body parts away from the seat area when removing and fitting the seat.
1
● The red markings on the floor locking mechanism→ Fig. 2
ensure that the red markings are never visible when the seats are installed.
indicate that the seat is not engaged. Please
Introduction
The following section shows the options for adjusting and removing the head restraints. Every seat is fitted with a
head restraint. Always ensure that your sitting position is correct .
Correct head restraint setting
Adjust the head restraint so that its upper edge is at the same height as the top of the head, but not lower than eye
level. Position the back of your head as close to the head restraint as possible.
Head restraint setting for shorter people
Push the head restraint all the way down, even if the head is then underneath the top edge of the head restraint.
There may be a small gap between the head restraint and backrest in the lowest position.
Head restraint setting for taller people
Push the head restraint up as far as it will go.
WARNING
Driving without head restraints or with incorrectly adjusted head restraints increases the risk of severe or fatal
injuries in the event of an accident or sudden driving or braking manoeuvre.
● If a seat is occupied, the head restraint for that seat must be fitted and adjusted correctly.
● Each vehicle occupant must adjust the head restraint to suit their body size in order to help reduce the risk of
neck injuries in an accident. As far as possible, the upper edge of the head restraint must be level with the top of
the head, but not lower than eye level. Position the back of your head in the middle and as close to the head
restraint as possible.
● Never adjust the head restraint when the vehicle is in motion.
NOTICE
When removing or fitting head restraints, make sure that they do not hit the roof, the front seat backrest or other
parts of the vehicle. This will prevent damage from occurring.
137
English 
