Wheels and tyres -> Tyre Pressure Loss Indicator for Your Volkswagen E Golf 4 Door Second Generation (2017-2020)

Tyre Pressure Loss Indicator  
Functional description  
The Tyre Pressure Loss Indicator uses data from the ABS sensors and other functions to check the  
speed of rotation and the rolling circumference of the individual wheels.  
The rolling circumference can change:  
If the tyre pressure has been changed.  
If the tyre pressure is too low.  
If the tyre has structural damage.  
If the vehicle is loaded more heavily on one side.  
If snow chains have been fitted.  
If one wheel per axle has been changed.  
The Tyre Pressure Loss Indicator may react with a delay or not display anything at all in the  
event of a sporty driving style, when driving on snow-covered or icy roads or unpaved roads or  
when driving with snow chains.  
Synchronising the Tyre Pressure Loss Indicator  
Switch on the ignition.  
Press the  
button or function button, depending on version (→ Vehicle settings menu,  
Operation).  
Open the Vehicle menu in the Infotainment system.  
Depending on version, touch function button Settings .  
Touch the Tyres function button.  
Touch the SET function button.  
When all four tyre pressures correspond to the required values, touch the Confirm function  
button.  
After an extended driving time with driving at different speeds, the system will automatically  
learn the new values and monitor them.  
The Tyre Pressure Loss Indicator must be re-synchronised under the following conditions:  
If the tyre pressures have been changed.  
If one or more wheels have been changed.  
If the wheels are swapped over, e.g. from front to rear.  
The Tyre Pressure Loss Indicator does not work if there is a fault in the ESC or ABS (→  
Brake support systems, FAQ).  
After a warning about the tyre pressure being too low, switch the ignition off and then  
back on again. The Tyre Pressure Loss Indicator can only then be re-synchronised.  
Troubleshooting for Tyre Pressure Loss Indicator  
Low tyre pressure  
The indicator lamp lights up yellow.  
There is a loss of pressure in one or more tyres or the tyre is structurally damaged.  
Do not continue driving!  
Check and adjust all tyre pressures (→ Tyre pressure, Introduction/General information).  
Damaged tyres should be replaced.  
Re-synchronise the Tyre Pressure Loss Indicator (→ Tyre Pressure Loss Indicator, Function).  
If the problem persists, go to a qualified workshop.  
Fault in the Tyre Pressure Loss Indicator  
The indicator lamp flashes for around 65 seconds and then remains lit up yellow continuously.  
There is a system fault.  
Do not continue driving!  
Switch the ignition off and then back on again.  
Re-synchronise the Tyre Pressure Loss Indicator (→ Tyre Pressure Loss Indicator, Function).  
If the problem persists, go to a qualified workshop.  
WARNING  
Differing tyre pressures or tyre pressures that are too low can cause tyre damage, tyre failure,  
loss of vehicle control, accidents, serious injury and death.  
If the indicator lamp lights up, stop the vehicle as soon as possible and check all the tyres  
(→ Tyre pressure, Introduction/General information).  
Different tyre pressures or tyre pressures that are too low can increase wear on the tyres,  
reduce vehicle stability and increase the braking distance.  
Differing tyre pressures or tyre pressures that are too low can cause sudden tyre failure and  
lead to a tyre bursting and the loss of control over the vehicle.  
The driver is responsible for the correct tyre pressure of all tyres on the vehicle. The  
recommended tyre pressure can be found on a sticker (→ Tyre pressure,  
Introduction/General information).  
The tyre monitoring system cannot function correctly unless all cold tyres have the correct  
tyre pressure.  
The pressure in all tyres must always be appropriate to the vehicle load (→ Tyre pressure,  
Introduction/General information).  
Always inflate all tyres to the correct tyre pressure before every journey (→ Tyre pressure,  
Introduction/General information).  
If the vehicle is driven with insufficient tyre pressure, this results in greater tyre flexing. This  
could warm up the tyre to such an extent that the tread may separate and the tyre could  
burst. This could cause the driver to lose control of the vehicle.  
High speeds and overloading of the vehicle may cause the tyres to heat up to such an extent  
that the tyre bursts, leading you to lose control of the vehicle.  
If the tyre pressure is too low or too high, the tyres will wear prematurely and the vehicle  
will not handle well.  
If the tyre is not “flat” and it is not necessary to change the wheel immediately, drive at low  
speed to the nearest qualified workshop and check and correct the tyre pressure (→ Tyre  
pressure, Introduction/General information).  
Driving on unpaved roads for long periods or a sporty driving style can temporarily  
deactivate the Tyre Pressure Loss Indicator. In the event of a malfunction, the indicator  
lamp will flash for 65 seconds and then light up continuously. However, the indicator  
lamp will go out when the road conditions or driving style change.