FOX 2004 ➤
3 - Cyl. injection engine - Edition 12.2009
1 - Oil pressure switch - F1-
0.3...0.6 bar, 25 Nm
2 - Guide bushing
3 - Oil pump
❑ Replace only the com‐
plete set.
4 - 25 Nm
5 - Crankcase
❑ Remove and install with
liquid joint ⇒ page 48 .
❑ Clean sealing surface
before installation.
❑ Install with Silicone
sealant -D 176 404 A2 -
⇒ page 48 .
6 - 15 Nm
7 - Sealing ring
❑ Replace.
8 - Oil draining plug, 30 Nm
❑ With sealing ring.
❑ Replace.
lk
9 - 8 Nm
10 - Cover
11 - 20 Nm + 90°
❑ Replace after each re‐
moval.
12 - Gear
❑ From roller chain
⇒ Item 13 (page 47) .
❑ After installation, adjust
distribution times ⇒ page 32 .
13 - Roller chain
❑ Mark rotation direction before removal (installation positions).
14 - Chain stretcher with tensioning chute
❑ From roller chain ⇒ Item 13 (page 47) .
15 - 15 Nm
16 - Chain gear
❑ From roller chain ⇒ Item 13 (page 47) .
17 - Supporting bushing
18 - Crankshaft pulley
❑ Remove and install Poly-V belt ⇒ page 13 .
19 - 90 Nm + 90°
❑ Replace after each removal.
❑ Fit lubricated.
❑ Immobilise crankshaft pulley with Spanner -3415- .
❑ The additional angle torque can be measured with a spanner, e.g. Hazet 6690.
20 - Oil level and temperature sensor -G266-
❑ Not applicable.
1. Lubrication system components - remove and install
47
English 
