WARNING
Driving on today's roads demands the full attention of the driver at all times. Driver distrac-
tion causes accidents, collisions and serious personal injury!
ꢀ
Never access menus when the vehicle is moving.
Emergency starting and starting the engine with a very weak vehicle battery or after the vehicle
battery has been replaced may change or delete settings (including time, date, personal convenience
settings and programming). Check the settings and correct as necessary once the vehicle battery has
built up a sufficient charge.
Using the instrument cluster menus: Basic version
Fig. 15 Basic version (vehicles without menu control multi-function steering wheel): Control buttons 1 and 2
on the windshield wiper lever.
ꢀPlease first read and note the introductory information and heed the WARNINGS
In the Basic version, the instrument cluster displays are controlled by the OK/RESET button and the
TRIP rocker switch on the windshield wiper lever (⇒ꢀfig. 15, (1) and (2)).
Switch on the ignition. The instrument cluster display is divided into 3 parts. The time (digital clock) is
displayed in the top part. The bottom part contains the odometer and the trip odometer ("trip"). The
display in the middle part is selected by pushing the TRIP rocker switch ((2)) on the end of the wind-
shield wiper lever. The available displays are as follows:
The available displays are as follows:
Fuel range estimate ꢀ (estimated distance you can drive with the fuel remaining in the tank).
Trip memory 1 (single trip memory) and trip memory 2 (total trip memory)
▪
Push the OK/RESET button ((1)) on the windshield wiper arm to toggle between trip memories 1
and 2.
▪
▪
Push and hold the OK/RESET button to reset a trip memory to zero.
The function of the 2 trip memories is explained in ⇒ꢀpage 27, MFI menu (Multi-Function Indicator):
Premium version, MFI menu (Multi-Function Indicator): Premium version. The 2 trip memories are
in addition to the trip odometer, which is displayed in the bottom part of the instrument cluster and
controlled using the 0.0/SET button on the right of the instrument panel ⇒ꢀfig. 10, ⇒ꢀfig. 11
ø --- mph (ø --- km/h) shows the average speed on trips per trip memories 1 and 2.
▪
Push the OK/RESET button on the windshield wiper arm to toggle between the two average speed
figures.
ꢀ---- mph (--- km/h) or xx mph (xx km/h). Use this menu to set or disable the speed warning
feature.
English 