Fig. 141 In the engine compartment: engine oil filler cap (general example).
Perform the steps in the order listed ⇒
:
1. With the engine at operating temperature, park the vehicle on a level surface to avoid an incorrect oil level reading.
2. Turn off the engine and wait at least five minutes for the engine oil to flow back into the oil pan.
3. Open the hood
⇒ Opening and closing the hood.
4. Find the engine oil filler and the dipstick. You can identify these by the
symbol on the engine oil filler cap fig. 141 and the colored handle on the dipstick
fig. 140. If you are not sure where the cap and the oil dipstick are located, contact suitably qualified professionals for assistance. Volkswagen recommends
contacting an authorized Volkswagen dealer or authorized Volkswagen Service Facility.
5. Remove the dipstick from the guide tube and wipe the dipstick off using a clean cloth.
6. Reinsert the dipstick into the guide tube and push it all the way in. If there is an alignment tab on the top of the engine oil dipstick, make sure it lines up with the
notch in the guide tube, and that the dipstick goes all the way in.
7. Remove the dipstick again and read the oil level on the dipstick as described below fig. 140:
The engine oil level is too high. If necessary, follow the messages in the instrument cluster display or contact an authorized Volkswagen dealer or
authorized Volkswagen Service Facility⇒
. Volkswagen recommends contacting an authorized Volkswagen dealer or authorized Volkswagen Service
Facility.
Oil level in the normal range. Engine oil can be added up to the upper edge of this area, for example if there is heavy engine load. Continue with step 8 o
step 16 ⇒
.
The engine oil level is too low. Add engine oil immediately. Continue with step 8.
8. After reading the oil level, reinsert the dipstick back into the guide tube and push it all the way in.
9. Remove the cap on the engine oil filler fig. 141.
10. Top up the engine oil gradually in small quantities (not more than 0.5 liters/0.5 quarts) or observe the recommendation in the instrument cluster. Volkswagen
recommends using the approved engine oils in accordance with the respective VW standard.
11. To avoid overfilling, you must wait at least one minute each time you add engine oil so that the engine oil can flow into the oil pan up to the marking on the oil
dipstick.
12. Read the oil level on the dipstick again before adding a little more. Never add too much oil
⇒
.
13. When you are done adding oil, the oil level should be in the center of area fig. 140
. The engine oil level must not be in the area fig. 140
.
14. If you accidentally add too much oil and the oil level is in area fig. 140
, do not start the engine. Inform an authorized Volkswagen dealer or authorized
Volkswagen Service Facility. Volkswagen recommends contacting an authorized Volkswagen dealer or authorized Volkswagen Service Facility.
15. Close the cap on the engine oil filler when you are done adding engine oil.
16. Insert the oil dipstick all the way into the guide tube. If there is an alignment tab on the top of the engine oil dipstick, make sure it lines up with the notch in the
guide tube, and that the dipstick goes all the way in.
17. Close the hood
⇒ Opening and closing the hood.
WARNING
Engine oil can ignite if it comes into contact with hot engine components. This can cause burns and serious injuries.
Always make sure that the engine oil cap is installed securely on the engine filler opening after adding oil and that the oil dipstick is inserted correctly in
the guide tube. This can prevent engine oil from leaking and coming into contact with hot engine components when the engine is running.
If engine oil spills on cold engine components, it could heat up and ignite when the engine is running.
NOTICE
If the oil level is in the fig. 140
range, do not start the engine, and contact an authorized Volkswagen dealer or authorized Volkswagen Service
Facility. Volkswagen recommends contacting an authorized Volkswagen dealer or authorized Volkswagen Service Facility.
When topping up fluids, make sure the correct fluids are added to the correct reservoirs. Using incorrect fluids can result in malfunctions and engine
damage.
Troubleshooting
Please read the introductory information and heed the Warnings and Notice ⇒
and Safety precautions for working in the engine compartment .
Engine oil pressure too low
The red warning light blinks. A message is shown in the instrument cluster display.
Do not continue driving! Engine damage could result.
242