50 amps
60 amps
Blue
Changing fuses
Plastic grippers for pulling out and inserting a fuse
(illustration).
1. If present, take the plastic grippers out of the fuse box or the cover of the respective fuse box → Fig. 2.
2. Push the plastic grippers clip suitable for the fuse type onto the fuse from the top or the side.
3. Remove the fuse.
4. If the fuse has blown, replace it with a new fuse with the same rating (same colour and same markings) and same size →
5. Once the new fuse has been inserted, put the plastic grippers back in the cover.
6. Insert the cover again or close the fuse box cover.
.
NOTICE
You can damage another location in the electrical system by using a fuse with a higher amp rating.
● Never replace a fuse with a fuse that has a higher rating.
For technical reasons, your vehicle may not be push-started → . If the engine cannot be started because the 12-volt vehicle battery
is flat, the discharged battery can be connected to the 12-volt battery of another vehicle to start the engine.
In vehicles with a 12-volt vehicle battery in the vehicle interior or luggage compartment, the jump leads must always be connected to
the jump-start connection points in the bonnet space.
WARNING
Using the jump leads incorrectly or performing the jump start procedure incorrectly can cause the 12-volt vehicle battery to explode.
This can result in serious injuries.
● Always read and observe the warnings and safety information before carrying out any kind of work on the 12-volt vehicle battery
(→ 12-volt vehicle battery).
● Never confuse the positive battery terminal with the negative battery terminal.
● Never perform jump starting on a vehicle with a frozen or thawed 12-volt vehicle battery.
WARNING
A highly explosive mixture of gases is given off when the 12-volt vehicle battery is jump started. The explosive gas can ignite due to
sparks when carrying out jump starting. This can result in serious injuries.
English 