Bora 1999 ➤ , Bora Variant 1999 ➤ , CC 2010 ➤ , Eos 2006 ➤ , Golf 199 ...
Electrical System, General Information - Edition 07.2010
– Tie back any excess in the uniform probe length (approx. 50 -
250 mm) to the size of the defective probe and secure with
cable ties -1-.
– Check that the connector housing of the Lambda probe is
compatible with the onboard supply side.
– If necessary, replace the onboard supply system connector
with the Lambda probe connector housing supplied
⇒ page 97
Note
♦ The connector housing should only be replaced on older ve‐
hicles. On new vehicles, the connector housing coding match‐
es.
♦ Observe pin assignment. For reasons of clarity, respective
pins in new connector housing have a colour marking.
♦ Further notes can be found in the leaflet of the new lambda
probe.
– Install the new Lambda probe in the vehicle.
4.2
Renewing LSU Lambda probe (6-pin)
Note
lk
♦ If necessary, replace attachment parts, cable ties or marking
rings to match the uniform probe to the defective probe as
specified.
♦ The wires should not be crimped or cut as otherwise the func‐
tion of the Lambda probe will be impaired.
– Remove the old Lambda probe.
– Place both Lambda probes next to each other so that the sen‐
sor housings are at the same height.
116
Rep. gr.97 - Wiring
English 