Advertisement

Advertisement

Renewing Lambda probe -> 4.1 Renewing LSF Lambda probe (4-pin) for Your Volkswagen Sharan VAN First Generation (1995-2010)

Bora 1999 ➤ , Bora Variant 1999 ➤ , CC 2010 ➤ , Eos 2006 ➤ , Golf 199 ...  
Electrical System, General Information - Edition 07.2010  
♦ VAG 1331  
Note  
lk  
The use of penetrating fluid, contact spray or grease etc. is pro‐  
hibited since the missing adhesion in the threads may cause a  
torque excess and, therefore, the break of the threaded connec‐  
tion.  
WARNING  
Danger of injury! Observe warning notices and safety regula‐  
tions ⇒ page 2 !  
– Disconnect battery.  
– Check battery clamp and battery terminal for corrosion or dirt.  
– Clean battery clamp using wire brush of battery terminal clean‐  
er with circular movements.  
112  
Rep. gr.97 - Wiring  
Bora 1999 ➤ , Bora Variant 1999 ➤ , CC 2010 ➤ , Eos 2006 ➤ , Golf 199 ...  
Electrical System, General Information - Edition 07.2010  
– Clean battery terminal using underside of battery terminal  
cleaner with circular movements.  
WARNING  
Danger of injury! Observe warning notices and safety regula‐  
lk  
tions ⇒ page 2 !  
– Reconnect battery and tighten battery terminals to specified  
torque.  
Note  
Optimum contact is ensured when the components to be secured  
are tightened to the specified torque after cleaning.  
3.1.4  
Anti-corrosion treatment  
Caution  
Missing anti-corrosion treatment results in damage to the on‐  
board supply.  
Note  
All threaded connections must be tightened to specified tor‐  
que.  
Always use hose supplied with anticorrosive agent tin.  
Use protection wax for cold area.  
Use cavity sealing agent for warm area.  
The sealing agent independently reaches the respective  
points through capillary action.  
– Hold injector below ring terminal and spray pin all around.  
3. Contact surface cleaning set VAS 6410  
113