Switching turn signals on and off
Fig. 1 On the left-hand side of the steering column: Turn
signal and main beam lever
Turn signals
1. Switch on the ignition.
2. Move the turn signal and main beam lever from the centre position to the following position→ Fig. 1:
A
—
—
Activate right turn signal .
Activate left turn signal .
B
3. Return the turn signal and main beam lever to the basic position in order to switch off the turn signal.
Go to a correspondingly qualified workshop and have the vehicle checked if the acoustic signal does not sound when
a turn signal is switched on.
Lane change flash
To operate the lane change flash, push the lever up or down to the point where you incur resistance and then release
the lever. The turn signal flashes three times.
To cancel the lane change flash, immediately move the lever in the opposite direction up to the pressure point and
then release it.
You can activate and deactivate the convenience turn signal in the vehicle settings in the Infotainment system
(→ Vehicle settings menu).
WARNING
Incorrect use of turn signals, failure to use turn signals, or forgetting to switch off a turn signal can confuse other
road users. This can lead to accidents and serious injuries.
● Always activate the turn signal in good time when changing lanes and performing overtaking or turning
manoeuvres.
● Always switch off the turn signal once the lane change or overtaking or turning manoeuvre has been completed.
The hazard warning lights also work when the ignition is switched
off.
Some settings can be stored in the personalised user accounts and therefore change when the user account
changes.
147
English 