Advertisement

Advertisement

Engine, exhaust system and fuel -> Engine oil for Your Volkswagen Virtus 4 Door First Generation (2018-2023)

Closing  
Engine, exhaust system  
and fuel  
1. Lift the bonnet.  
2. Unhook the bonnet stay and insert it into the  
holder.  
Bonnet  
3. Fold the bonnet down and release it from  
a height of 20 cm.  
Opening the bonnet  
4. Check that the bonnet is closed.  
Before opening  
NOTICE  
1. Make sure the windscreen wiper arms are fol-  
ded down onto the windscreen.  
Do not press down on an unclosed bonnet.  
·
·
Open and close the flap again.  
2. Keep away from the engine compartment.  
Opening  
Engine oil  
Specification  
— Pull the release lever underneath the dashboard.  
Engine oil sticker  
A
B
Engine oil specifications  
Engine oil viscosity  
The engine oil sticker is located at the front of the  
engine compartment.  
— Release the lock.  
— Open the bonnet.  
Vehicles with an engine oil sticker:  
— Remove the bonnet stay from the holder and in-  
sert the end of the stay into the opening in the  
bonnet.  
Bonnet  
99  
If the engine oil needs to be topped up, use the oil  
indicated on the sticker at the front of the engine  
compartment.  
Vehicles without an engine oil sticker:  
You can obtain information about the engine oil  
specification prescribed for your vehicle from a spe-  
cialist garage. If the engine oil needs to be topped  
up, use this oil.  
When using the prescribed oil, the level can be  
adjusted as often as required.  
— The oil level must be within the marked range.  
In an emergency  
NOTICE  
If engine oil of the prescribed specification is not  
available, you can once add until the next scheduled  
oil change a maximum of 0.5 l of engine oil with the  
following specifications:  
Risk of damage to the engine and the exhaust sys-  
tem!  
The oil level must not be outside the marked  
range.  
·
— VW 504 00, ACEA C3 and API SP, viscosity 0 W-30  
If the oil level is below the marked area, do not  
continue driving, stop the engine and seek assis-  
tance from a specialist garage.  
Volkswagen recommends that oil change is  
then carried out by a specialist ga-  
rage » page 4.  
·
If the oil level is above the marked area, continue  
driving with appropriate caution, and seek assis-  
tance from a specialist garage.  
·
Checking the fill level and topping  
up  
Do not use any oil additives.  
·
Refuelling  
Depending on the driving style and operating condi-  
tions, the engine may consume up to 0.5 l/ 1000 km  
Consumption may be higher over the first 5,000 km.  
1. Unscrew the cover of the engine oil filler open-  
ing.  
2. Top up the oil to the correct specifica-  
tion » page 99 in 0.5 litre portions.  
— Regularly check the oil level.  
Test conditions  
3. Check the oil level.  
4. Screw on the cover of the engine oil filler open-  
ing.  
Vehicle on a flat surface  
Engine switched off, at operating temperature  
NOTICE  
Checking the fill level  
Volkswagen recommends using approved engine oils  
in accordance with the relevant VW standard. The  
use of engine oils that do not comply with this  
standard could damage the engine.  
1. Wait a few minutes for the engine oil to flow  
back into the oil sump.  
2. Remove the dipstick and wipe with a clean  
cloth.  
Volkswagen recommends engine oils from the  
Volkswagen Genuine Parts product range.  
3. Insert the dipstick as far as it will go and pull it  
out again.  
Replacing  
4. Read the oil level and push the dipstick back in  
again.  
Volkswagen recommends that oil change is then  
carried out by a specialist garage » page 4.  
100  
Engine, exhaust system and fuel  
Troubleshooting  
Coolant  
Engine oil pressure too low  
Coolant temperature gauge  
flashes, simultaneously illuminates  
Or:  
flashes, simultaneously illuminates  
— Check the engine oil level.  
The oil level is OK, the warning light continues to  
flash:  
— Stop the engine and seek assistance from a spe-  
cialist garage.  
A
Low temperature  
Engine oil level too low  
— Avoid high engine speed.  
Operating temperature  
High temperature  
illuminates together with  
B
C
Or:  
— Avoid high engine speed.  
illuminates together with  
Message indicates required engine oil top  
up.  
— Check the engine oil level, top up with oil if re-  
quired.  
Checking the fill level and topping  
up  
Engine oil level too high  
Test conditions  
illuminates together with  
Vehicle on a flat surface  
Engine switched off and cold  
Or:  
illuminates together with  
Message indicates the need to reduce the  
engine oil level.  
Checking the fill level  
— Check the engine oil level.  
Engine oil level too high.  
1. You may continue driving, exercising appropri-  
ate caution.  
2. Seek assistance from a specialist garage.  
Engine oil level sensor malfunction  
illuminates together with  
The fill level must be within the marked range.  
Or:  
— If the level is below the  
ant.  
mark, top up the cool-  
illuminates together with  
Message indicates required engine oil top  
up.  
NOTICE  
Danger of damage to the engine compartment!  
1. You may continue driving, exercising appropri-  
ate caution.  
Do not top up the coolant above the marked area.  
·
The coolant could be forced out of the cooling  
system when heated.  
2. Seek assistance from a specialist garage.  
Coolant  
101