Advertisement

Advertisement

Wheels -> Tyre pressure for Your Volkswagen Virtus 4 Door First Generation (2018-2023)

3. Use the crank to raise the jack until its claw enc-  
loses the bar.  
4. Continue to lift the vehicle until the wheel is  
just off the ground.  
Replacing a wheel  
1. Loosen the bolts and place them on a clean sur-  
face.  
2. Carefully remove the original wheel.  
3. Fit the replacement wheel.  
4. Contact tighten the bolts.  
5. Lower the vehicle.  
1. Place the wheelbrace on the wheel bolt or on  
the attachment piece.  
2. Turn the bolt a maximum of half a turn so that  
the wheel does not come loose and fall off.  
NOTICE  
Applies to the factory built or the Volkswagen Genu-  
ine Accessory range anti-theft bolt.  
Jacking points  
The jacking points are on the bottom of the vehicle's  
lower sill.  
Install the anti-theft wheel bolt in the position  
·
marked on the back of the wheel trim.  
Tightening the bolts  
1. Tighten opposite wheel bolts, including the an-  
ti-theft wheel bolt, one after the other.  
2. Reinstall the cover caps on the wheel bolts or  
the full wheel covers.  
Keep the label with the code number of the  
anti-theft wheel bolts. A replacement attach-  
ment can be purchased from the Volkswagen Genu-  
ine Parts.  
A
B
16 cm  
26 cm  
Tyre pressure  
Positioning the jack and lifting the vehicle  
What you should be mindful of  
NOTICE  
NOTICE  
Use the jack from the tool kit.  
·
Always adjust the tyre pressure to the load.  
·
·
Check the pressure in all tyres at least once  
a month and before each long journey.  
Check the pressure when the tyres are cold. Do  
not reduce the higher pressure of warm tyres.  
·
After each change in tyre pressure, save the new  
values in the tyre control display.  
·
WARNING  
1. Position the jack at the jacking point closest to  
the wheel to be replaced.  
Risk of accident!  
If the tyre pressure loss is very sudden, try to  
·
2. Support the base plate of the jack with its full  
surface resting on level ground and ensure that  
the jack is located in a vertical position at the  
jacking point.  
stop the vehicle carefully without heavy steer-  
ing or heavy braking.  
Tyre pressure  
115  
Label with the specified tyre pres-  
sure values  
Function restriction  
The system is unable to provide a warning in the  
event of a very rapid tyre pressure loss, e.g. sudden  
puncture.  
The sticker for storing tyre pressure readings is loca-  
ted on the centre body pillar on the driver’s side.  
The system function may be restricted in the follow-  
ing cases:  
— Uneven load on the wheels  
— Sporty driving style  
— Driving on dirt roads  
Storing the tyre pressure  
1. Inflate the tyres to the specified pressure.  
2. Turn on the ignition.  
A
Information about pressure check with cold  
tyres » page 115, What you should be mindful of  
3. Save the tyre pressure by one of the following  
methods.  
B
C
D
Tyre pressure reading in case of partial load  
Tyre pressure reading in case of full load  
Storing the tyre pressure using button  
Specified tyre pressure value for the spare  
wheel  
1. Press and hold the button on the key bar.  
The indicator light  
on the instrument cluster  
illuminates. After the tyre pressure values have  
been saved, an acoustic signal sounds and the  
indicator light goes out.  
Tyre pressure monitor  
2. Release the key.  
Functionality  
Storing the tyre pressure values in the Infotainment  
system  
The tyre pressure monitor indicates a change in tyre  
pressure.  
10" Infotainment system:  
In the following menu, select the item to display the  
vehicle status:  
Warning when pressure changes  
illuminated  
1. Tap  
.
2. Select the screen with the vehicle status menu  
by swiping with your finger.  
1. Stop the vehicle.  
2. Check the tyres and tyre pressures  
3. Select the vehicle status menu item.  
4. Select the tyres menu.  
Displaying tyres with modified pressures  
5. Press the  
button.  
10" Infotainment system:  
6. Follow the instructions on the screen.  
1. Tap  
.
2. Select the screen with the vehicle status menu  
by swiping with your finger.  
When the tyre pressure needs to be saved  
Save the tyre pressures in the following cases:  
3. Select the vehicle status menu item.  
4. Select the tyres menu.  
— Change of tyre pressure  
— Change of one or more wheels  
— Change of position of a wheel on the vehicle  
— Always after 10,000 km or once a year  
116  
Wheels