Tyre pressure storage label
2. Remove the cover cap.
The process for storing tyre pressures is also shown
on a label on the central body pillar on the driver’s
side.
Installing
— Push the cover cap onto the wheel bolt to the
stop.
Full wheel frame
Removing and installing the trim
Applies to factory built or Volkswagen Genuine Ac-
cessories trims.
Removing
1. Hang the clamps for removing the wheel trims
at the edge of one of the openings in the trim.
1
2
Inflating the tyres to the specified pressure
Saving the values
2. Push the wheelbrace through the clamp, push
on the tyre and pull off the wheel trim.
Installing
Troubleshooting
1. Press the wheel trim onto the wheel rim at the
designated valve opening.
Restricted function / system fault
When using an anti-theft wheel bolt, it must be
located as shown on the bezel.
flashes approx. 1 minute and then remains il-
luminated
2. Press the trim, starting at the valve, into the rim
on both sides until it engages around the entire
circumference.
1. Stop the vehicle, switch off the ignition and
start the engine.
If the
indicator light flashes again after start-
NOTICE
ing the engine there is a fault in the system.
2. Continue driving, exercising appropriate caution,
and seek assistance from a specialist garage.
Use hand pressure, do not hit the wheel cover.
·
Wheel bolt cover caps
Removing and installing bolt caps
Removing
1. Insert the extraction pliers from the tool kit into
the hole in the bolt cap.
Wheel bolt cover caps
117
English 
