2005-2017 Aston Martin Vantage 2 Door Controls -> Trip Computer User Manual
MyCarUserManual.com
USER MANUALS FOR EVERY MAKE & MODEL

Controls -> Trip Computer for Your Aston Martin Vantage 2 Door Third Generation (2005-2017)

4.14
Controls
Lamps ON Warning
If the vehicle side lamps are ON, and the driver's door is opened after
the vehicle key has been removed from the ignition control, an
audible warning will sound for a period of five minutes. To stop the
audible warning set the lamps to OFF. The audible warning will also
stop when the driver’s door is shut - the lamps will stay ON.
Instrument Brightness
During the daylight hours the level of instrument brightness defaults
to maximum brightness.
During the twilight and night time
hours a twilight sensor (A) located in
the centre stack, automatically reduces
the level of brightness to a preset level.
If the twilight sensor is covered the
level of brightness will stay low as if in
night time mode.
The level of brightness can be
reduced by using the rotary
control (B). If the brightness level
has been adjusted, the twilight
and night time brightness level
will return to the previous setting
on the rotary control, each time
the sensor picks up the twilight
hours.
Push the rotary control in and
release to enable the control.
Push in and release to lock the
control.
Trip Computer
Press the button (A) for less than
three seconds cycles through the trip
computer functions one at a time. Trip
computer information is viewed in the
message centre.
If an information message
shows, after reading and acting
on the information provided
press the READ button (B) to
return to the trip display.
4.15
Controls
Range: Estimated travel distance with fuel
available (no reset). The minimum distance
shown will read 12 MILES. Below this distance
will show ‘- - -’.
Average Fuel: Average fuel consumption
since last reset. Press A for more than
three seconds but less than five seconds to
reset. Press A for five seconds or more will
reset both the average fuel consumption and
average speed. INFOCENTER IS RESET will be
shown in the message centre. Press the READ
button to acknowledge the message.
Instantaneous Fuel: Shows the fuel
consumption over the last three seconds of
travel (no reset).
Average Speed: Shows the average speed
since last reset. Press A for more than
three seconds but less than five seconds to
reset. Press A for five seconds or more will
reset both the average speed and average fuel
consumption. INFOCENTER IS RESET will be
shown in the message centre. Press the READ
button to acknowledge the message.
Present Speed: Shows the current vehicle
speed.
Driver aid only.
Trip computer default screen.
Tire Pressure Monitor : Shows the current
tire pressure for all tires (Refer to ’Tire
Pressure Monitoring’, page 4.18).
Blank Screen: Blank screen will show.
Display Units
The display can be set to show metric or imperial units.
With the ignition ON press the READ
button (C) and the Trip Computer button
(D) together for three seconds to change
the trip computer display units.

Related Topics

Popular Owner Manuals